Jump to content
SAU Community

Recommended Posts

dox ran off with the raffle items and the salad... everyone was left raffle less and salad less. :)

Actually wha happened tot he raffle goodies and the salad?

We all left at 3pm I went to work, 3 of em ih to Altona etc.

i've got the pics on my camera, I'll upload when I get home.

Thik we raised about $220 today.

The meet was great and i have some great pictures to upload (if i could make the size smaller 1Mb per pic :( )

On the dyno day, which hopefully will be happening soon, i will try to bring a set of "wheel weighers" (scales) that are sometimes used by the RTA to weigh trucks, etc. , so that we could weigh and maybe do a suspension ballance on our cars (for those who have coil-overs).

Hope to see you all soon, as well as those that could not make it to this meet.

GREAT freinds, GREAT bbq, GREAT day, Great pics, and a GREAT (but confussing [:) Ash] cruise to Altona.

C ya

Alan

hehe hopefully I'll have my car ready for a true dyno run this time. Last time was a 86rwkw with a slipping clutch, black oil and badly untuned :) no CAI. hopefully this time I should go up to about 90rwkw :(

I got pics too... will post shortly... on this thread

Thanks everyone for your help and contributions. We still have all the raffle items - so with just the BBQ, raised a bit over $200!!

Would like to do the raffle before MAS, so stay tuned this week for details. Probably dinner somewhere (pizza) - more fun for the whole family!

Once again - thanks heaps to everyone, and I hope no one got sick from my rather poor burning of the eggs :D

James W

Good effort!

Now we just need to get the cars organised. :uh-huh:

When should we know if we've had any knock backs?

It would be a tad annoying to get cars ready, then find out that they can't be displayed. :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
×
×
  • Create New...