Jump to content
SAU Community

Recommended Posts

mate, i havent done anything, havent kissed her or anything...so there u go

it was a serious threat....but its not like i havnt been in the boat of being threatened b4....cos u all know what im like when it comes to some 1 have1 a go at me...

yeh im in the right and have done nothin wrong....but people r people and some r dummer than others..such is life

its pushed 396 :)

i had 1 turbo drop back to .5 bar instead of 2 at 1.6, car was wheel spinning with 6 people in it at 5500rpm and we still managed 350 on pump fuel :(

anywayz...they werent gettin along when he came in on saunday to mas, so he made her leave early, she told me monday they had a fight and it was ova, she broke it off with him...and yeh, u should b able to c how its my fault...riiiittteeeee

Guest 180sx_nissan_guru

i say take leewahs ride, and roll over that ****er, slice him into bits.

what did it do on the MAS dynos? 463kw? yeah that that ****er and run him over :) personally, i would track him down and pipebomb his house ;) i can make em if ya want lol just call me hahahahaahaha :)

Tweak :(

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...