Jump to content
SAU Community

Recommended Posts

this is NOT one for the faint hearted!

you need:

male and female 8pin plugs (jaycar)

32 core 18-20awg cable 2m of it

8core cable - 3m

twin core shileded cable - 2m

single core cable shielded - 2 m

LOTS of heatshrink

6 hours of patience...

nets this:

starting:

DSC_0065r.jpg

original harness with the new one sitting behind it - those are CAN lines that I'm adding 2m of cable to..

DSC_0066r.jpg

new spot for the OE unit

DSC_0067r.jpg

note the black plug - 2m of extension lead there- no lead - no audio from external sources or anything else for that matter..

DSC_0068r.jpg

new 2m extension - one plug in place

DSC_0069r.jpg

better than crimps or tape (and certainly better than the hack job on G35driver!!)

DSC_0070r.jpg

OE nav done and tested in its final spot

DSC_0072r.jpg

all done! (top gear FTW!!)

-------------

anyone wanting this one done - find another person- I'm not doing another.

Link to comment
https://www.sau.com.au/forums/topic/211308-moving-nav-dvd-unit/
Share on other sites

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

cookie,

if its the rear one you have then it does not affect it. waz car has a rear one. I simply will not repeat that exercise due to the time it took. unit is under the passenger seat. you do not have to electrically disconnect teh seat so it gets a bit easier. if you do disconnect the seat be aware that you will set the airbag light when you turn the key on.

if I get overwhelmed with requests I'll make up a plug in lead for it.

I'd be in for a harness . PM me if you have the data and want someone to manufacture them. I'd be happy to do low volumes.

This I would think would be a very worthwhile and fundamental mod.

Include a rear Aux TV lead harness as well.

What would a harness cost roughly?

I presume the harness would include din socket for the new DVD unit.

gibbo

I have a local place that can do them. plugs are the worst bit of it. thing being I have to buy a 1000 of each plug and the matching pins ( there are 5 of them )MINIMUM to make them. the main nav plugs are EXPENSIVE - so for the total harness it would be in excess of $300 to make properly. the TV AUX lead I keep on hand anyway - ready made for $60-75 depending on exchange. same rule there.

the estimate I did was a plug in lead with the two CAN plugs (both sides) 8 pin DIN plugs and the main nav plugs with 2.5m of lead between them. the nav antenna plug is irrelevant as that gets replaced in most cases with a new antenna anyway. (Iin the cars I do IT DOES GET REPLACED)

the above exercise was $60 in cable and connectors.

  • 2 weeks later...

Hi Chris,

Awesome work, im looking at doing something similiar myself in the future when i find the patience!!

One quick question, does the car operate without the OEM Nav unit installed?? If it is unplugged does it have a hissy fit?

Cheers

Laine

it will. nothing will work screen wise but yes the car does run and drive with no lights. have driven SEVERAL cars around with no dash in them at compliance doing exactly what you are asking.

what do you have in mind?

if you do disconnect the seat be aware that you will set the airbag light when you turn the key on.

Do you mean that once anyone do this, the airbag light will stay on FOREVER even though the ignition is turned back off, seat wire is reconnected, and turn it back on?

Cos there's someone on the other thread that's got an engine error message as he accidentally tried to start the car with airflow meter plug disconnected. now it seems he has the dreaded errror message FOREVER even though the car works fine now.

nope. if I had removed the seat ENTIRELY and turned the key on then I would have the same problem as the OP does. I didnt as I left the wiring intact and pushed the seat out of the way. have high res shots if you wish to look. only way to get rind of the codes is with the appropriate bit of sofware and a cable.

it will. nothing will work screen wise but yes the car does run and drive with no lights. have driven SEVERAL cars around with no dash in them at compliance doing exactly what you are asking.

what do you have in mind?

Ok fair enough. I was just trying to take the easy option and just remove the nav unit and replace it with a DVD unit and attach that to the aux input mentioned in the other thread. Pretty much the same as what you did!

Never mind, might just have to look at taking the same approach when the time comes....

  • 2 weeks later...

What do you reckon of this? 40GB HDD, its' own CPU, functions as a dvd player as well...

http://cgi.ebay.com.au/1-DIN-In-Dash-DVD-C...1QQcmdZViewItem

I should've put the dvd player in when chris did the conversion work saves all the troubles now...

I came across the Nesa DVD-5051 as well, 1/2 DIN size so looks like slim enough to fit in e.g. glovebox or tucked in somewhere less obvious.

http://www.nesavision.com/dvd5051.html

Is this just as good as the other DVD-8000 that you told me about?

Hey now that should allow the existing unit to be set down and to the rear of where it is and the slim unit up and forward. That way no rewiring of the existing unit.Would depend on unit price as well.

Brillliant.

I get my v35 back next week so will check it out mate. Mine may well be the first v35 coupe to have tangled with 2 kangaroos (mother and joey) in the country certainly off the road for 3 months. They liked HID so much they leapt head first into the left one.

I can't wait ...

Gibbo

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi from Canada, Both of my calipers are starting to fail. My car is a 2005 M35 Stagea ARX and I can't seem to find any parts or any cross reference caliper that would fit my car. Is there a company or a similar caliper that would fit and I could replace the OEM one. Or if anyone knows where I can find a new OEM. Any help is very appreciated. Let me know!
    • Maf is a question mark but TPS  I have set at 0.47, the fact that I’m getting proper voltage range out of it with the key on leads me to believe it’s functioning properly. I’m getting proper voltages on basically everything. I still need to look up voltage ranges for z32 maf and test that 
    • Honestly no not at all, but it’s a very basic tune, it’s stock injectors q45 tps and z32 maf. Other than that it’s a completely stock base map. The file is from nistune and from my understanding if it was tune related I would be able to unplug maf and tps and it would still start even if it was a really shitty start. I have tried starting it with coolant temp, maf, and tps unplugged none of those 3 togethor or individually changes anything 
    • 🏆 Skyline Supremacy Meets Mount Panorama Magic 🏆 Join SAU NSW as we take the long way to Bathurst, the home of GTR greatness. Saturday 30th August 2025 7:00AM Meeting Hanna Park North Richmond 7:30AM Departure Cruise Via Bells of Line Road 9:00AM Arrival to Stop 1: Golden Poplars Meadow Flat 9:45AM Arrival to Final Destination: Mount Panorama Motor Racing Circuit Meet Location: Hanna Park North Richmond Stop 1: Golden Poplars Meadow Flat Final Destination: Mount Panorama Motor Racing Circuit   *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day   Highway gets as low as 10l/100km on my end so I'm not as worried about it being a mechanical issue. More likely just the tune on the haltech.
×
×
  • Create New...