Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

I am not getting into ANOTHER "east side ppl are too lasy/tight to drive their cars!" arguement ;)

I chose Westgate bridge, as it is central to most people. Some of us (low-lux, etc.) has to come from sunbury which is almost an hour drive to the westgate! I wouldn't want to make him, or others, drive 1.5-2 hrs just for a general meet.

Funky: Where is this "usual" spot you mentioned? Have you been cruising/meeting with you imaginary friends again?:)

Link to comment
https://www.sau.com.au/forums/topic/21593-weekly-meetup/#findComment-457909
Share on other sites

Alright to be fair, I voted Albert Park. Than we can play Schumacher afterward hehe.

I think the location is pretty good too for cruise as it is close to Princess for any cruise in the SE, E and is not that far from Westgate as well.

Pretty central and not in the heart of the City. But don't know of any big carpark thu.

Link to comment
https://www.sau.com.au/forums/topic/21593-weekly-meetup/#findComment-458032
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...