Jump to content
SAU Community

Angry, Angry Man From Croydon Abusing Vic Roads

Lachlan33
 Share

Recommended Posts

Lachlan33 Community Regular

Lachlan33

Posted
Posted

http://members.optusnet.com.au/tiks01/vicroads.wav

I am sure its probably been posted here before but god its hilarious.

And scary. Just think, this person drives. I would NOT want to be the cop that trys to give him a bald tyre defect or something haha

BLK33T Community Regular

BLK33T

Posted
Posted

Thats gold

I work in a call centre >>get at least 1 a week like that >> i would have egg'd him on LOL

now sir there no need for that attitude LOL >> i can't understand you sir please speak clearly LOL ...

passive aggresive is the way to go with dickheads like him ...

RAWRx7 Rookie

RAWRx7

Posted
Posted

i find the best way for me to get my way is usually to stay on the phone and keep argueing (sensible argueing points of course) until they give in, works for me most of the time, but its never my fault thats probably why... happends when call center jobs get sourced to india

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      Cold compression test after rebuild... should I be worried?

      By Duncan · Posted

      How have you run it in / what has been done in those 6 hours? Also, you need to do the test hot. You have to load the new motor pretty hard to bed the rings in quickly and properly, doing it on the dyno is best and only takes an hour-ish The other question is.....what were the measured clearances post machining and do they match the specs for the piston and rings
    • Duncan
      Another little story of weird shit happening

      By Duncan · Posted

      Sounds like a good outcome, must be nice to have it working well, and yes everyone seems to top out under 250rwkw with a low mount rb25 so you are in the right ballpark. It really would have been worth setting up the boost controller at the same time, but at least now you can share some back to back data on how much difference holding the gate closed until you need it makes
    • WMDC35
      first time swapping rb25det into r34

      By WMDC35 · Posted

      I've done this both ways, I'd use the original loom & swap plugs on the engine side as you'll usually end up changing a lot of those anyway. Series 1 is usually non ABS which requires wiring which I can't remember how to do as haven't done it for over 15 years. The auto inhibitor is easy to bypass or in the meantime you can put it in neutral & unbolt it & tape it somewhere in the bay haha, then just wire reverse lights. I'd go straight to aftermarket ecu. A few basics are built in ignitor coils & reverse the CAS wiring, sort the plugs for whatever injectors & IAC-you can use an adaptor for the neo type otherwise the s1 will still work, use the knock sensors that suit the loom & it'll be pretty much running.  
    • MidnightR32
      Cold compression test after rebuild... should I be worried?

      By MidnightR32 · Posted

      This is for an RB20DET. Sorry for not including that. 
    • MidnightR32
      Cold compression test after rebuild... should I be worried?

      By MidnightR32 · Posted

      Welp, this is where my compression lands after my rebuild. Thoughts? I have ~6 hours on the motor. 
×
×
  • Create New...