Apexi Full Auto Timer On Bnr32

[Godzilla32]

Hey everyone, i just read that you can't use the auto function on a BNR32. Apparently its to do with the car using titanium o2 sensors. Has anyone got a BNR32 and managed to have it work? I had planned to buy one of these for that reason alone...

Deren

[paulr33]

the feature is junk anyway, it just watches the narrow sensor and guesstimates engine load

usually it sets the auto idle time really high, to around 1.5 minutes which is too much

you can just adjust it, but its not really needed.

just set it to manual mode and dial in 30 seconds or whatever idle time you want

[Godzilla32]

Ok thanks for that. Still disappointed lol

[paulr33]

haha why - its a crap feature

[Godzilla32]

Ive had a Greddy one that runs off the RPM before and it sucked. They reckon the Apexi one can tell you the A/F ratio. Thats pretty cool. I can't see it being that bad...1.5 mins would be ok. I used to run mine for 1 min manually....Anyway i cant use it so why am i talking about it lol.

[paulr33]

the a/f ratio it gives out is useless, as its from the stock narrow band sensor

its slow and it jumps all over the place

16.0

15.2

19.1

16.2

16.5

20.0

and so on...

[Godzilla32]

Fair enough, your destroying my dreams lol

[paulr33]

if you want cool gadgets check out the prosport gauges on youtube.com

[Godzilla32]

Ok, i was mainly just after a good auto turbo timer.

[DRIFTER]

i tested one on an evo 8 against my wideband last week and it was pretty accurate. wouldn't tune with one though.

[Godzilla32]

Ok thanks mate. Still disappointed i can't use that feature...

[Juan]

i got the apexi turbo timer installed, the auto function would be pretty useless. i just

set to 30 seconds