Jump to content
SAU Community

Recommended Posts

hey!, i gave my car a bit of shit around a corner today and i lost boost halfway around it???

now i get no boost at all!

i no the turbo was on its way out (smoking and squeeling etc)

could this be the intercooler piping? i tryed to look for leaks but didnt see anything or is the turbo just dead?

mods: rb25, micro tec, 3 inch turbo bk,fimic, 040, ebc etc 10 psi

cheers dylan

Link to comment
https://www.sau.com.au/forums/topic/218885-no-boost/
Share on other sites

Jesss where do we start...

so you have no power/boost when you drive now... What about any noises that were not there before???

have you looked over the little vac line that goes to the actuator on the turbo and made sure it has not just popped off???

if intercooler piping pops off you'd know about it as the car would run like a dog on 2 legs in a greyhound race...

how much smoke you blowing? did the smoke increase now that the car does not make power???

Link to comment
https://www.sau.com.au/forums/topic/218885-no-boost/#findComment-3860902
Share on other sites

if intercooler piping pops off you'd know about it as the car would run like a dog on 2 legs in a greyhound race...

Not true.

He is running a Microtech, therefore, will have no AFM. Check the intercooler piping (including the pipe straight off the turbo and also into the plenum), that is the most likley cause.

Link to comment
https://www.sau.com.au/forums/topic/218885-no-boost/#findComment-3861273
Share on other sites

in my old s15 a part of the turbo-dumppipe gasket was deteriorating, and a piece got jammed in the turbo exhaust wheel, was giving same as above, no boost car reved like a n/a car. but it was obvious the gasket was gone from the noise it made. when i replaced the gasket, and removed the gasket piece from the turbo wheel everything back to normal with full boost etc.

probably should take the turbo off anyway and have a look

Link to comment
https://www.sau.com.au/forums/topic/218885-no-boost/#findComment-3861303
Share on other sites

Worst case scenario, you have a leaking gasket or a crack piston ring land.

Once the turbo is taken out check the turbo and the exhaust manifold bolts. Sometimes bolts can come loose.

If everything looks good. Do a compression test and check for oil leaks.

Edited by Tomei_Powered
Link to comment
https://www.sau.com.au/forums/topic/218885-no-boost/#findComment-3862276
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...