Jump to content
SAU Community

Recommended Posts

Hello Skyline enthusiasts and gurus alike.

I have the following problem (I'm pretty sure it's a problem). When I take off from a standing position, a loud and noticeable "click" comes from the rear of my car. It also does it when reversing, and braking 80% of the time. It's got me stumped. To be honest, I'm not a skyline expert, I've owned my car for over a week now. I'm pretty sure this is not normal. :domokun:

Tonight i took it into the garage under some light, and jacked up the rear of the car and spun both tyres with my hand. I heard no noise.

I then started the car up and while the back was raised, I accelerated slowly in 1st, then changed to 2nd. Still no click. Tried it in reverse as well. I still can't find the click.

I went under the car and did a half assed inspection. Moving majority of the bits underneath the car for any immenent sound. Still no luck. :O

Has any one had this problem before? Do some skylines do it from wear and tear, or is it an aftermarket component that was put on that makes the sound? I'd appreciate any help.

cheers!

-Ang

Link to comment
https://www.sau.com.au/forums/topic/223888-a-click-sound-coming-from-the-rear/
Share on other sites

excuse me, just noticed a couple of other posts of a similar nature posted here... i apologise

I'm thinking worn rear driveshaft. Or maybe a bush? wouldn't hurt to get them both replaced even if they dont need to be done.. 100,000 k's service coming up soon.

Edited by SinistR33

I rang up a CV joint, they reckon it's not a CV. Because if it was it'll make a continuous clicking sound. So I rang up Pedders and i'm getting a suspension check tomorrow.

It might be a bush. I have just had my front bush's replaced because they were worn, so the back being worn sounds about right.

That, or maybe a driveshaft/ uni fault.. we'll find out soon enough.

I assume the first thing you did was inspect your tyres to make sure you haven't picked up anything?

No i didn't actually. But I might do that. But the way I see it, if something was picked up by the tyre, then there would be a continuous noise. I tailshaft, or suspension sounds about right.. And maybe CV's, even though apparently the cv's will make a constant noise, but you'd never know.

- Ang

you'd think so but no.....you only notice it when taking off or slowing...could be because at speed the sound will change from a click to a continuous noise and just blends into the drone/road noise with everything else.

Never know your luck.

Yeah, thumb tack, nail anything that shouldn't be there.

If you jack the car up and rotate the wheels just rub your hand over the tread surface and check nothings sticking out.

doing this will also eliminate an egg (deformed lump) or flat spot in your tyre as the problem.

ok so I took the car to Pedders to get a 28 point safety check, and to see whats causing the rear click. The safety check costed me nil due to waiting time (2 hours) so saved some money there. Also the car seems to be very neat. With only upper control arm bushes slightly worn, which gives the car a bit of a knock when going up driveways etc. I was told to bring the car back in 6 – 12 months for another inspection and see how they are going. But due to me always having bad luck, it was a good day.

* Now for the clicking* Good news, the diff, the cv’s, all suspension components in the rear are in very good condition. Only thing to be making that noise that they thought, would be the brakes. Like something moving in the calliper. Ill take the car into a brake shop, and get that sorted out.

I read somewhere here on the forums that someone suspected it to be like the pad moving when under load or tyre direction change. So it may just as well be that.

While I was there, there was this other chap that has a 33 and he overheard me and his car had the same problem. But it didn't phase him as he was getting rid of the car soon.

Ive also got a noise like that (R32 gtst); it sounds like a solenoid clicking on and off. But i reckon its coming from my brakes or drive shaft on the drivers side. When i jack the car up and its in gear, i can turn the rear wheel a few degrees and kinda replicate the noise. I was thinking that it might be something inside the rear drum (handbrake) assembly. Either that or a worn rear drive shaft.

It pisses me of intermittantly, then i forget about it.

Shaun.

Ive also got a noise like that (R32 gtst); it sounds like a solenoid clicking on and off. But i reckon its coming from my brakes or drive shaft on the drivers side. When i jack the car up and its in gear, i can turn the rear wheel a few degrees and kinda replicate the noise. I was thinking that it might be something inside the rear drum (handbrake) assembly. Either that or a worn rear drive shaft.

It pisses me of intermittantly, then i forget about it.

Shaun.

Yeah buddy i thought so too, but I had it all checked out, including diff and everything, and sounds like a brake issue. Well mine anyway.. But heaps of people had the same sound but mechanics couldnt fault it. I havent had my brakes checked yet, but yeah, trial and error, and this is the last place to look! No big deal though anyway.

It must of been a generic fault with the R33's if it's a common problem. But unless your unlucky, its nothing major

  • 1 month later...

Has anyone found the cause of this problem? i get it too and it's really shitting me.

It clicks once everytime the driveline is loaded in a different direction (taking off, reversing, overrun from releasing throttle sharply).

I also get constant clicking when i'm above 60kmh. it gets louder when i load up the drivers side (corner left). also have tried spinning up the tires to 70kmh while the rear is on stands but doesn't happen when the car is jacked up.

Has anyone found the cause of this problem? i get it too and it's really shitting me.

It clicks once everytime the driveline is loaded in a different direction (taking off, reversing, overrun from releasing throttle sharply).

I also get constant clicking when i'm above 60kmh. it gets louder when i load up the drivers side (corner left). also have tried spinning up the tires to 70kmh while the rear is on stands but doesn't happen when the car is jacked up.

Sounds like you have worn universal joint/s. I had the same issue in my bluebird. Hope this helps

Try tightening your wheels pretty dam tight, And if u have bolt on spacers take your wheels off make sure there really tight and then put your wheels back on and tighten them right up.

I had the same problem and took it to Tyre power they where clueless to what it was, they tightened the wheels and i left.. listened.. no clicking.. so i was happy.. But when i turn i get it a little coming from my front end but i think that could be just cause my front bolt ons aren't tight.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • When you crank your car, and hit it with a timing light, can you see a steady crank timing?
    • Oh, forgot to add, A few months ago I was getting mixture codes and the car was using crap loads of fuel. You could smell the unburned fuel in the exhaust, it was crazy strong. Economy was over 17.5 l/100 and usually around 19. I smoked the engine and found a leaky CCV hose which I replaced and then I replaced my two pre cat O2 sensors, I also replaced the MAF. This fixed my mixture codes and improved my exonomy but I'm still 14 - 15 l/100 when pottering about town so something is still amiss. Throttle response is much better and it has more pep but I'd like to know why it's still so thirsty (and I'm hoping that whatever it is gives me a bit more poke).    
    • Car is on factory injectors/z32 maf/ q45 throttle body/ z32 ecu with nistune 
    • Hello all, currently finishing up a rb25 swap into my s14. Having issues with starting, car has spark (confirmed by pulling a plug and watching it spark), has fuel(confirmed by checking pulse/voltage at injectors all spark plugs are soaked in fuel). Car cranks over and pops into the exhaust with a heavy fuel smell but no attempt to start or run, I have torn the timing cover off and triple confirmed timing, turned the CAS in multiple spots both directions, attempted to start with coolant temp and maf unplugged, checked my fuel lines and made sure they weren’t backwards, checked voltage at cas/injectors/coilpacks, made sure all the grounds in the harness are connected and added a few grounding straps (1 from chassis to block, 1 from chassis to head, and 1 from chassis to igniter chip) I am getting stumped here. As a last ditch effort I made a full grounding harness tonight that’s going to run from the battery and add an extra ground from the battery onto the coil pack harness/igniter chip/ intake manifold/ Wiring specialties harness ground/ and alternator. I’m hoping maybe the grounding harness will fix it here but posting here to see if anyone has any other ideas on what else I can check. My fuel pressure is unknown right gauge will be here tomorrow.  IMG_3206.mov
    • yeah I was shocked when I checked my spare OEM on and as below that's how they come from Nissan. (side interesting note new NEO gearbox and replacement park lack the brass bush on the tips and its just all alloy) unsure about damage to the box currently back at 1110 to be pulled down/inspected and selector fork replaced as he built it previously and given the never before seen failure on his billet forks he is replacing it under warranty. He said he has used always OEM the keyway tab without issue for years so it could be an unlucky coincidence. I did talk to him about the sharp corners and stress concentration too. Re: hard shifts i got 7+ years out of the OEM one and the fork itself failed not the keyway. so could be bad luck as I said or an age thing + heat cycles in box and during fabrication of billet?
×
×
  • Create New...