Jump to content
SAU Community

Recommended Posts

anyone know what the hose running from the intake pipe closest to the jay pipe to the back of the power steering pump is for ? some days i seem to have vairing degrees of feel to the steering . appears to get heavier when driving spiritedly and quite light when just cruising . any thoughts ?

99 RS four S

Edited by lachlanw
Link to comment
https://www.sau.com.au/forums/topic/228725-vairable-power-steering-assistance/
Share on other sites

consider a power steer fluid cooler, sounds like the fluid is heating up, changing its viscosity, creating the heavy steering feel. Most of the Skylines are fitted with a small tube one, our cars were not designed be thrown around as much. Not sure what the hose is, also consider changing the fluid, i use transmax Z in my PS, found it gives a lighter feel and handles the higher temps better. Ive been planning a PS cooler for a while now, ill get round to it soon.

there may be easier and less messy ways, but the way I do it is, 2 hoses on bottom of resovoir, one is fluid return, other is fluid out. Place towel under resovoir, unhook return hose, (dont ask me which one is which ?) need to plug up hose connector on bottom resovoir immediately to stop it draining, use same diameter piece of hose with tight bolt in other end. I then extend this return hose with another piece of hose and a hose connector so you can feed it into a waste container. get new fluid ready, have mate turn on engine and make sure resovoir starts draining, if not then you prob have wrong hose, once nearly empty start filling resovoir, keeping a good fluid level, have mate turn wheel side to side a few times. Once drained fluid colour changes to new fluid, stop, reconnect, check level. Go for drive, check level again.

had my cover off today and there is a line running from the afore mentioned intake pipe to what looks like something similar to an oil pressure sender unit its on the line coming out of the power steer pump. has another line coming off it that is dissapears down by the block . and by heavier steering i mean it has more feel and need to hold on tighter . by no means is it heavy heavy

Edited by lachlanw

On series 2 neo (not sure about s1) there is 2 pipes connected to the power steer pump.

One line connects the the intercooler pipe which runs between the intercooler and the throtle body.

There is a second line which runs behind the timing belt cover and connects to the inlet plenum near the fuel reg

I had mine disconnected for a while when I fitted the fmic as the kits do not come with the extra nipple in the intercooler line

To be honest I did not fell much difference, but I did only drive it for a few hundred k's like this. I then fitted a new nipple to the intercooler pipe and hooked it up again.

It most be reading boost pressure, so when pushing the car, ie on boost, there must be a change to the power steer feel by operating a pressure relief solinoid on the back of the pump. That is my guess.

The one I've been driving is noticeably heavier on the highway/at higher speeds than it is around town, in fact its very light at low speed. This is consistent too. Surely it must have some sort of variable assist?

yerah i agree with you guys aye . sometimes if you are taking off during a 3 piont turn ie taking off while on full lock and give it a bit of boost it has real heavy steering but goes away straight meh . i like it how it is tho . seems to be set up at a farily good ratio for how i like my steering . two hands when you boostin it and light as when cruising on thw high way

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I used to have Walbro 255's when they were a pretty common update. (or were they 044? 040?) In any case I had a dirty tank. I thought the tank was good, but I would find the filter would clog in maybe ~50km of driving. If the issue persists, well, your fuel system or tank has crap in it that the pump is sucking up.
    • Hi. Ok thanks for the info. I/we do not know what tune is on that Nistune ECU so it is why there is stock ECU and that Nistune is for later when the car is done. I have guy who tunes Nistune and other ECU so i will then take it to him to see and properly tune for the car   And for the update. On 99,9% it is bad fuel pump. Which is wierd cuz it is like 2 years old(brand new walbro 255) and that filter (also brand new) was dirty.  I was alwaya pumped premium(100) on very good petrol station so i dont know how is that possible...  
    • Dear folks My family members have 4 different cars : Triton 2015 and Corolla 2011 and Mazda3 2012 and Hyundai Elantra 2014 Looking to buy engine oil funnel spill free What I found are are below  https://www.amazon.com/gp/aw/d/B0BBTTJNKX?ref=ppx_pt2_mob_b_prod_image&th=1 https://www.ebay.com.au/itm/145553221359?srsltid=AfmBOoqYBU6Ptw0LU_bAp_k67U3qkF97HHvePkA7iHZw8vUmiwoIRaRr https://www.amazon.com/gp/product/B09X23TCS5?th=1 Is there a funnel with attachment that fits most cars ? Don't mind to spend for a decent quality  Thx  
    • Stock ECU (or more accurately stock tune) absolutely refuses to go over 10psi and behaves like you have seen. The Nistune is the same if it is the stock tune. If the Nistune chip has been tuned, the resulting tune could be literally anything for any combination of parts. The Nistune just makes the stock ECU Tunable.
    • So stock ECU does not like anything above 10 psi?  That Nistune one is just for "try" if it will be any different, I know it need to be tune for that. I know but YOU may know about these problem but i/we dont. They few little Skylines here let alone people who know anything about tham so that is why iam asking here  
×
×
  • Create New...