Jump to content
SAU Community

Recommended Posts

  • Replies 665
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Hoodies?? Wheres mine?? oh damn i missed it didnt i !! when's the next round of hoodies??

There should be a national hoodie group buy in about 3 weeks, keep an eye out in my sig and in the group buy section.

  • 2 weeks later...
What's going on with the Hoodies???

and why did all the threads disappear and the new one created doesn't work????

What's going on????

AM I BEING SCAMMED????

try reading the entire thread. it may very well answer your own question

here i'll save u the effort; no you're not being scammed. take a trent pill and f**ken relax ay

-D

Yeah, sorry it came accross that way, I wasn't actually that worried. forgive me..

Just didn't understand why everything just disappeared. all good now..i get it.

And Dohmar, I have read the thread, as it was written, and that was before the others were created. :laugh:

There will be no more from me on the subject :D

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...