Jump to content
SAU Community

Recommended Posts

O.k., just purchased the car and I wanted to give the car an oil change. Problem came about as I tried to put the drain plug back in. The threads on the oil pan are stripped and have been stripped. Does anyone know of a drain plug repair kit that I may be able to purchase instead of buying a new pan? I checked auto parts stores but they don't have any.

thanks,

mls

p.s.

the oil filter is so 'easy' to replace. :D All the wires in front of the oil filter didn't help either.

Link to comment
https://www.sau.com.au/forums/topic/23949-oil-pan-drain-plug-repair/
Share on other sites

the best thing to do is drill the thread out and retap it bigger size then u have to get a bigger plug . u should be able to do that on the car after u drain the oil , use a magnet to colect all the metal shavings from the sump ( very important ).

When redrilling load the drill bit with grease to help catch chips anf is possible lightly pressurise engine with air hose to prevent chips entering sump.

Then wash out sump with the oil you drained (into a clean container) after using magnetic pickup thru sump plug hole to pick up any stray chips.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...