Jump to content
SAU Community

Recommended Posts

after a lot of talking and reading i have changed my mind from gtss turbos to Garrett 2860R-5.....

i will have all the surport mods sorted! its a built motor to....

i have been told they will come with gaskits ect but what needs to be modified to fit them just the oil return line? do i need a oil restrictor in the line going to the turbos?

any advice would be great!!!!

this is for a r32 gtr also

thanks in advance steve

Link to comment
https://www.sau.com.au/forums/topic/243305-garrett-2860r-5/
Share on other sites

ported head matched manifolds

jun guilds stano vavles

stock cams

stock cam gears and springs

baffled sump oil restrictors in the block cam cover plates

jun collar and oil pump

acl race bears mains and big ends

rev rods

cp pistions

1.3mm metal head gaskit

metal inlet manifold gaskits

pfc

stock cooler

stock inj stock fuel pump

stock air flow meters

stock dump pipes

front pipes 3 inch cat 3inch exhuast and cannon

stock turbos

os giken twin plate clutch

eboost 2 set to 13psi

262rwkw 351hp

i also have sard 720cc inj now and a sard pump and greedy hard pipe kit is on the way.... i will also be getting nismo afm

Link to comment
https://www.sau.com.au/forums/topic/243305-garrett-2860r-5/#findComment-4240593
Share on other sites

so did you just use the stock gaskits? new ones of course.....

pritty much.. they came with my tomei gasket kit as i did head gasket at the same time aswell as a couple other things

nice list of parts, you'll need afm's aswell if your goin the -5's, either nismo's or Z32's

Link to comment
https://www.sau.com.au/forums/topic/243305-garrett-2860r-5/#findComment-4240622
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
    • So 10/10 times that code is coil packs? I mean if that's the case ill drop the $400USD or so to replace them. I didn't know these cars threw codes before the issue became an issue.
×
×
  • Create New...