Jump to content
SAU Community

Recommended Posts

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

currently i dont want to split gear box and transfer case,

If you do decide to split the box I'm after the plate inside the bell housing that the pivot bolt mounts on. Mine cracked when removing broken pivot bolt thread. PM me

If the C-Pillar trim is in good condition I will take them. Mine are cracked, It was the c-pillar ones I was after but I better double check that the c-pillar trims go around the quarter glass on the inside. Better be safe then sorry.

Wrecking 1989 R32 GTR, has rear right hand damage,

All Parts are located in Logan QLD

all parts available

RB26dett, $3500

GTR gearbox, $800

headlights, $300

Justjap inter cooler, $250

front mount oil cooler,

GTR radiator, $80

Front Bumper Reo, $250

Rear Bumper Reo, $100

Front Bar fiberglass, $180

standard GTR front bar, $300

GTR rear wing, $150

plenty of other parts f/s, please pm me.

Interested in the GTR bonnet can you post some pictures as to what condition it is in and what price would you like for it

thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...