Jump to content
SAU Community

Recommended Posts

Hi guys,

Just thought I would throw in my 2c if that's ok:)

turbo cars are fitted with bovs that plumb back - this is something the manufacturer does, and for good reason (another story)

atmo BOV vent crank case gasses to the atmosphere - this is in direct contradtion of road traffic acts australia wide, and it also contravenes EPA reguations.

It took me a while to work out why atmo BOVs are illegal, until I was reading ADRs with regard to crank case gasses.

All vehicles manufactured after 197? (from memory) must burn crank case gasses through the cylinders as part of emissions control - this is where the problem lies, as under boost crank case gasses go into the intake after the afm and before the turbo (which is why we fit catch cans). Once we take out foot off the accelerator, those gasses vent to atmo.

Hope that clarifies.

As for noise, the only regulations I could find were on vehicle exhaust noise, as for removing a 'turbo whistle' OMFG how can you remove something that doesnt exist - should take him to court purely on the principle - like to see the copper produce a dictionary (or any other legitimate) definition of a 'turbo whistle'. If a defect notice is a legal document, shouldnt the issuing copper be under some sort of requirement to get his terminology right?

Should get a statement off a mechanic to the effect that there is no such thing as a turbo whistle, then go see the guys supervisor and make a complaint that you wasted time trying to remove something that doesnt exist:)

CRANK CASE GASSES are different form your bov gasses.

catch cans are used to stop- the amount of shitty blow by in your engine. mostly used for ****ed cars, or crazy high performance cars. bov's vent air that has come from your air filter, thru your turbo then thru the intercooler to your pipes.

there must be different laws in SA. as this is the Queensland section.

now listen. Atmo BOV are legal.so long as they comply to the noise and polution levels.

Where do the crank case gasses go when under boost?

All cars create blow by, whether only a little or alot. If you have a look at the two connectors on top of the rocker cover you will see that they go to the intake, after the AFM, as under boost the gasses cannot go into the plenum for obvious reasons, which is prevented by the PCV (positive crankcase ventilation) valve.

If the gasses did not go into the intake, or were vented to atmosphere, the crankcase could pressurise and cause all sorts of problems (like blowing gaskets and seals - not pretty)

It was only in the early seventies that cars started being required to comply with emissions standards, and the gasses could not longer be allowed to vent to atmosphere.

If the rest of you emissions control is correctly plumbed up, there is no physical way you can stop some crank case gasses getting into the charge air. It is this charge air that vents when the BOV lifts, hence atmo is not street legal.

The requirements for cars to comply with emissions standards are the same in every state.

  • 15 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
×
×
  • Create New...