Jump to content
SAU Community

Recommended Posts

I was told that not having mesh over the intercooler is illegal Ricca, I don't have it on mine, but my car is also very sticker worthy, I'm just lucky *crosses fingers*

haha ur a girl you can play with their minds !!

:P

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4330610
Share on other sites

  • Replies 85
  • Created
  • Last Reply

Top Posters In This Topic

Was the guy that you had an Italian looking guy. Slightly short and chubby? that’s the guy i had when i first took my car over, he was picking on stupid little things and he was trying to tell me that he could have my car destroyed if he wanted to which is total crap! Little Hitler. he gets a tiny bit of power and it goes to his head.

Any way i took it back to o’connor again and got tall old bold guy and he was very polite and friendly. it went over fine. took all or 10 seconds of the him to check the car was ok and didn’t even bother to check a few things on my list. He was talking to me about how he liked skylines, the new 35GTR and about ripping skids in his wife’s V8 lol

i don’t think it makes a difference where you go so much as who you get when you go.

Oh and if anyone is having to go over the pits and has a fairly low car i recommend you get in the line for the pit closest to the entrance gate because the edges of the pit are a little lower on that one. All the others have a small drop off in the concrete where as this one does not. My car has just less than 100mm clearance and i was worried about it but went over that one fine. Also don’t go over with too much fuel in the tank because that will drop you down a fair bit.

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4330736
Share on other sites

Damn... this sucks Ricca. I've only ever had one yellow *touches wood* and I went to Welshpool. They were pretty good to me. The guy even gave me this booklet and said, "I see you want to mod your car so here is a booklet of guideline" Couldn't believe it after all the horror stories I'd heard haha

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331035
Share on other sites

I can pretty much guarantee you wont get over with the fibreglass bonnet/guards, unless you know someone. Also i doubt youll find your intercooler is actually cold...... it just cools down the hot air passing through.

1st time i went over the guy didnt care about bonnet / guards he was a good guy he race's V8's or some doodle he only did me due to shockie leak and bold tyers

so i got coilover and fixed everything 2nd time this guys picked on everything (different guy )

Well i will try my luck on wenesday at Whelspool so touch wood it works out!

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331161
Share on other sites

prob will meet you there as i am taking my car over. i am bit worried about my car passing as i just had a RB26 put into it, but heard isnt much prob cause its an opional engine or something like that. does any one know more about this

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331165
Share on other sites

bubba on here got his car past without engineer certs and his engine is a full 1litre increase

i usally go after lunch as thats when everyone is gone and no cars at all haha.

Edited by Flash89
Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331214
Share on other sites

Give midland a go, i passed mine there quick as and i have a cf bonet along with many other mods and the guy commented on it at first then laughed n said i was all good to go. Oh and you have to book your car in @ Midland so you dont need to wait 4 hrs.

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331241
Share on other sites

prob will meet you there as i am taking my car over. i am bit worried about my car passing as i just had a RB26 put into it, but heard isnt much prob cause its an opional engine or something like that. does any one know more about this

Only thing I reckon they might balk at if they're not in the "know" is the "twin" turbo thing (like insurance companies flip out).

Swapping engine as i know need Enginerring cert or complaice plates or something to 100% sure

but yersh might see u their will be going very earily!

Only if it's vastly bigger or different than the original engine.

bubba on here got his car past without engineer certs and his engine is a full 1litre increase

i usally go after lunch as thats when everyone is gone and no cars at all haha.

It was as simple as change the engine number from RB20xxxx to RB30xxxx :D

Give midland a go, i passed mine there quick as and i have a cf bonet along with many other mods and the guy commented on it at first then laughed n said i was all good to go. Oh and you have to book your car in @ Midland so you dont need to wait 4 hrs.

I went to Midland also, booked the earliest available appointment (7:30am I think it was) which might have been the key to getting a nice inspector.. I think there was 3 or 4 lanes and he probably picked my lane as after talking to him, he rather liked skylines and thanked me for driving my car :D

Hmm actually, that was 2nd pass.. now that I think about it I think I got the same guy both times, first pass rego'd the engine and just found some minor stuff like an exhaust hanger off, a split boot had to secure the pod filter and a bit of piping better. Second time over he just checked the items he noted the first time and off came the sticker.

Maybe with the booking system they can utilise the inspectors better so that instead of being so random (and swamped), you get an inspector that knows your type of car..

Edited by bubba
Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331321
Share on other sites

Midland are pretty cool, got my pulsar re-rego'd there.

There is a place in Geraldton that I got my Torana inspected, he pretty much let me do the inspection myself and let me recitify most of the problems there and then, lol.

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/2/#findComment-4331379
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I would just put EBC back on the "I would not use their stuff" pile and move on.
    • Can I suggest you try EBC directly again and link them to as many competitor catalogues as you can to show their listing is incorrect, eg https://dba.com.au/product/front-4000-series-hd-brake-rotor-dba42304/ If you have access to an R33 GTST VIN and your VIN, you could also use a Nissan Parts lookup like Amayama to show them the part number is different between 33 GTST and 34 GTT which may get their attention
    • So i got reply from EBC and they just this site where you can clearly see those 296mm fronts on R34 GTT. I send them photos and "quotes" that 296mm are not for 34 GTT and they are too small. But it will be very hard to return them cuz nobody here knows 100% and they just copy those EBC catalogue :-D https://ebcbrakesdirect.com/automotive/nissan/skyline-r34
    • Hi, is the HKS  Tower Bar still available ? negotiable ? 🤔
    • From there, it is really just test and assemble. Plug the adapter cables from the unit into the back of the screen, then the other side to the car harness. Don't forget all the other plugs too! Run the cables behind the unit and screw it back into place (4 screws) and you should now have 3 cables to run from the top screen to the android unit. I ran them along the DS of the other AV units in the gap between their backets and the console, and used some corrugated tubing on the sharp edges of the bracket so the wires were safe. Plug the centre console and lower screen in temporarily and turn the car to ACC, the AV should fire up as normal. Hold the back button for 3 sec and Android should appear on the top screen. You need to set the input to Aux for audio (more on that later). I put the unit under the AC duct in the centre console, with the wifi antenna on top of the AC duct near the shifter, the bluetooth antenna on the AC duct under the centre console The GPS unit on top of the DS to AC duct; they all seem to work OK there are are out of the way. Neat cable routing is a pain. For the drive recorder I mounted it near the rear view mirror and run the cable in the headlining, across the a pillar and then down the inside of the a pillar seal to the DS lower dash. From there it goes across and to one USB input for the unit. The second USB input is attached to the ECUtec OBD dongle and the 3rd goes to the USB bulkhead connected I added in the centre console. This is how the centre console looks "tidied" up Note I didn't install the provided speaker, didn't use the 2.5mm IPod in line or the piggyback loom for the Ipod or change any DIP switches; they seem to only be required if you need to use the Ipod input rather than the AUX input. That's it, install done, I'll follow up with a separate post on how the unit works, but in summary it retains all factory functions and inputs (so I still use my phone to the car for calls), reverse still works like factory etc.
×
×
  • Create New...