Jump to content
SAU Community

Recommended Posts

  • Replies 85
  • Created
  • Last Reply

Top Posters In This Topic

edit---TODAY--i was down at welshpool (getting my licence re-newed, no yellow sticker) there was stuff all cars there, a disgusting red celica with huge chromies, and a pig s13.

THOUGH i went in n came out in 30mins and the line hadnt moved at all. that was around, 2pm

Edited by Char
Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4333523
Share on other sites

how did you go ricca, no luck for me. got to see if my brides are adr approved, my park light reflector has to be secured, high level stop light, need tyre plark. car re weight. need to have proof that the car doesnt come with a air bag. high beams. (they worked before i left to go) got to fill out this mod form and send it through and prob have to get a engineer to look at it.

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4334598
Share on other sites

sorry if i am jacking this thread, but how am i meant to prove that my car doesnt come with air bags

the easiest way to prove you dont have airbags is to look at your dash lights. If you have an airbag, upon igntion of the car, the airbag light will come on for a brief few seconds as a self check. If there is no airbag light at all on the dash...the car never came with it.

Edited by ZXY
Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4335789
Share on other sites

mmm when i got a yellow and went to the pits i went to the gosnells one *i had a yelloow for a T wing* i got this guy with like skin disorder and he raped me :? saying my suspension is wayyy too hard and couple of other stpuid stuff so i got my mom to take my car over at welshpool and it was done in less then 10 secs :) so yeah if i was to get a yellow again ill get my parents to take car over LOL

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4336067
Share on other sites

  • 2 weeks later...

Well thought i give an update.

I have since my last Check installed a new

Immboiser!!

inner toe arm

fixed the Suspension

and made a bracket for the Zaust

Heading over the pits on Monday not sure where yet i have got a friend which is a Engineer and getting his Cert to Clear his own cars

he would be taking it down so he can talk the talk!!

So hope all goes well!

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4352960
Share on other sites

where would the engine number be on the 26, the inspector couldnt find it cause he said the turbos are in the way

Exactly where he's looking. There's a little bit of the block that sticks out, on the passenger side, up against where the gearbox bellhousing bolts onto the block.

He might need to use his little bendy mirror and get at it from the underside..

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4354713
Share on other sites

actually found the engine number, i guess on a 26 its different, its directly under the top radiator hose on the block

lol fair enough, they probably moved it after they realised they'd put a bunch of turbos and stuff in the way :)

Link to comment
https://www.sau.com.au/forums/topic/249806-pits/page/3/#findComment-4355601
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
    • For DBA, check out their guide table here. https://dba.com.au/wp-content/uploads/2023/01/Direct_Replacement-Guide-2021.2.pdf   Additionally they have some other guides and info on how to make sure you choose the right pad.
×
×
  • Create New...