Jump to content
SAU Community

Recommended Posts

Take two ………. After the last effort she’s on again

Weather permitting I was going to go out and settle a score I have with a friend who has a 200sx s15 that he thinks might give me a run for my money.

I thought I might put it up here in case anyone else wants to come.

[b]SAT 10.1.09[/b]

Gates open at 4pm and runs commence at 4.30pm

Event fees $38.oo to race, admits the entrant and one other

Spectators $19 adults & $17 students with ID

Children 13 & under free

Requirements

Helmet to Australian standards

Long sleeve shirt

Long pants

Covered shoes

Cheers

Phil

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/
Share on other sites

I don't know about video footage but there will definately be photos.

He is not a bad lad he is taking me to Sydney to see Top Gear Live on the 7 FEB. :banana:

Phil

Don't be a fool ,he is showing you his fear... :rofl:

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4349958
Share on other sites

Hi

Well I have come back with my tail between my legs and I am sorry but I gave it my best shot. He had me off the line every time and no matter what I did I could not catch him up again. From the 60ft through to the finish line we were very even. It just goes to show that power to weight plays a big part in it all

post-25786-1231585295_thumb.jpg.post-25786-1231586850_thumb.jpg

My best time was 15.456 @ 125.64 KPH reaction 1.026 60ft 10.203

His best time was 14.854 @ 124.31 KPH reaction 0.885 60ft 9.817

post-25786-1231586272_thumb.jpg

Now I know the photo is not grate but should I be worried about the amount of smoke coming from the exhaust. This was the last run for the night.

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4360037
Share on other sites

Hi

I knew it would be close but I didn't think he would actually beat me. When he does get it on the dino we can actually compeer the power to weight off both cars.

As far as the smoke goes it is still there but only when you give it a boot full. From inside the car it appears to be grayish black (An over rich mixture at high rpm) but on the video it appears to be a bluish color

I have taken the plugs out and replaced them even though the old ones seem to be in good condition

I also did a compretion test while the plugs were out (wet & dry test and they are all within 20lb from the worst 140lb to the best 160lb).

I will keep an eye on oil and fuel consumption over the next few weeks.

Phil

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4365680
Share on other sites

"My best time was 15.456 @ 125.64 KPH reaction 1.026 60ft 10.203"

i will use your time as a benchmark STAGE1 as i will be taking my S2 RS4-S to willowbank either 22nd or 24th Jan to see what it runs.

my mods are only 3" catback, pod filter, 10psi.

Also just noticed you run the enkei rims. i have the exact same set from my MZ20 soarer (selling if someone wants it 3k) which are 17x8 and 17x9. I am obviously too lazy here, do you know if the stud pattern is the same ?

Cheers

Jez

Edited by Jezboosted
Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4365709
Share on other sites

What launch technique did you use? Did you hold your left foot on the brake, accelerate a bit to build boost, then let the brake go and nail the accelerator as the light went green?

yeah what he ^ said. :(

try snow mode, torque split button, manual shifting?

so wish SA had a strip. this sux that we've got shit all.

so just a cat back and max boost (as mine came when I got her from qld almost 4yrs ago) gets 15.4

Im pretty sure thats the same time CoolPC did.... http://www.skylinesaustralia.com/forums/Ni...50#entry4366250

Im sure mine would do low 13 now (duno?) but just wont know until there's a track here in adelaide.

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4366251
Share on other sites

Q. Did you have any victims?

A. Sorry but I did not have any wins we only managed 3runs for the day. Race 1&3 the 200sx beat me if only by a smidgen and race 2 I was beaten by a woman in a skyline who I found out later had a rebuilt RB26 with a big single turbo. She ran a 12.3

Q. What launch technique did you use?

A. race 1 was right foot on the brake in drive then slips it across to the go pedal when the light turned green

Race 2 was left foot brake in drive revs up to 1,800 then it was off with left foot and down with the right

Race 3 was left foot brake in first power button on revs up to 2,000 then it was off with left foot and down with the right

Hit the rev limiter in 2nd this cost me a 10th

Note- we never got into top gear and the car seamed to do better if it was left in drive something I have noticed even on the circuit

I went out expecting to do around 15.2 or at best a high 14 so I was pretty happy with my effort

Jez

let us know what day you are going out and I will come and watch

Phil

Link to comment
https://www.sau.com.au/forums/topic/250947-qr-drages-10109/#findComment-4368192
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • As I wait for parts to be delivered, I have managed to procure via a contact a R32 Nistune ECU......for now I just want to monitor what the car is doing but eventually.......who knows where we go 😂
    • To back this up, I'm always looking on the outside, seeing the level, and then opening it up anyway, as I'm worried the level I've looked at, is more so a scunge line. Then you end up dipping your damn finger in it too depending on the type of tank you're looking at just to make sure I'm not going insane.   PS, Mark, polish up the none moroso one a bit and then give it a clear coat. The Moroso one looks to be way shiner (not mirror polished, just shinier) and it'll still look weird with the two different alloys beside each other. Either that, or Id probably paint them a flat black...
    • Good old Orange Park hey... 😛   f**k I miss that race track
    • lo, it was a death trap. Good times. Got any Fatz Drift Day DVDs still available?
    • Yes, overthinking. Many PS reserviors are completely opaque. Our Skyline ones, for example. Have to remove lid, peak inside, swirl the dipstick, try to remember how to read it, etc etc. Normal. Radiator overflows are often sufficiently opaque and scunged up that you can't see the true level inside anyway, and have to open and have a peak. Besides which, I replaced the (massively expensive, even back then) plastic overflow in my Alfa GTV, back in the '90s with a stainless one that I had a good fabricator make up to be dimensionally same-same, that looks remarkably similar to the Bogan's Moroso one above, and I never suffered any particular paranoia that I didn't know how much coolant was in it.
×
×
  • Create New...