Jump to content
SAU Community

Recommended Posts

hey pple i have searched and i could not find what i was looking for :P

at moment im running (splitfire coils )0.8mm gap in my r33 heat range 7 and i was thinking of going to 1.1 mm gap....

would these improve my millage and make the car run better ?

or should i stick to what i have now?

i have read of some people running 1.1 gap successfully with upgraded coil packs?

mods are basic filter,zorst,10psi,coller,splitfires

Link to comment
https://www.sau.com.au/forums/topic/252709-splitfires-and-11mm-gap/
Share on other sites

i know lines drink a lot but if it was able to run on 1.1 plug i tough would make the car run better and in gain receive extra mileage and power .

just reading thru some spark plug threads people seemed to run a 1.1 gap and got a much better burn of fuel making the car run better.

that's why i asked about the bigger gap

You can run a 1.1mm gap, quite easily.

Even on 10PSi...

I run a 1.1mm gap, and was at one point pushing 18PSi off a big huffer turbo, into a 3.0L block, without an issue of misfire.

I was also running 12PSi on the RB25 setup with a 1.1mm gap, without an issue in the world.

The stock plug gap is set at 1.1mm, and the FRESH coils from the factory, will run this, even with a few PSi more being thrown at it, so why wouldn't a set of coils that generate from memory a 50% stronger spark?

You can run a 1.1mm gap, quite easily.

Even on 10PSi...

I run a 1.1mm gap, and was at one point pushing 18PSi off a big huffer turbo, into a 3.0L block, without an issue of misfire.

I was also running 12PSi on the RB25 setup with a 1.1mm gap, without an issue in the world.

The stock plug gap is set at 1.1mm, and the FRESH coils from the factory, will run this, even with a few PSi more being thrown at it, so why wouldn't a set of coils that generate from memory a 50% stronger spark?

thanx for that , i was researching if it would be ok to run a 1.1 plug as per specs as i have new coils and only minor bolt on bits.

the reason for post was to see if anyone else has done it, i did not say i will do it,or will not but, why not ask and save on time and changing sparkies over when you can get a answer from pepole that actually have this setup and running it like MBS206

I agree. Iridiums are a waste of money. What gap you will be able to run with out the car missfiring will depend mainly on the condition of the coilpacks. If they are old and overheated and cracked then the car will missfire. If they are in good condition then it show easily be able to run 1.1 gap.

And i thought splitfires werent any stronger than new stock coilpacks... has this 50% stronger spark been proven?

And i thought splitfires werent any stronger than new stock coilpacks... has this 50% stronger spark been proven?

they must be stronger. i havent heard of anyone running new nissan coilpacks in heavily modified cars. splitfires are a common choice for racing applications.

on my splitfire box it has a graph showing a dyno comparison, an RB making 323ps with regular coilpacks, and 330 with splitfires. theres also another graph which i assume is something to do with spark or volts or something (its in japanese) but the splitfires easily outperform the comparative product.

Ah k just because lots of people say that they arent actually any better. They are just more popular because the are less than half the price of new nissan coilpacks from the dealers. Although i know there are many 400kw gtr's running stock coilpacks without any problems.

With the graph, were the nissan coilpacks old or new. Cos obviously new splitfires are going to outperform 20year old nissan ones..

Ah k just because lots of people say that they arent actually any better. They are just more popular because the are less than half the price of new nissan coilpacks from the dealers. Although i know there are many 400kw gtr's running stock coilpacks without any problems.

With the graph, were the nissan coilpacks old or new. Cos obviously new splitfires are going to outperform 20year old nissan ones..

well thats a very good point. everyone rubbished kkr turbos a while back, many people still do, but they seem to go alright for people who actually tried them, inc. myself.

the graph says splitfire vs "normal", engine is an rb26dett. so if theyre new factory coilpacks, 7ps is a pretty big gain.

i didnt even consider the cost, i though splitfires were fkn expensive. but then again, genuine nissan is a total rip off for just about everything.

LOL yeah apparently genuine new nissan ones cost near $1000 so splitfires are half that price which is why they are a good choice even if they arent any better.

But i guess if they are better than new stock ones thats an added bonus

hey must be stronger. i havent heard of anyone running new nissan coilpacks in heavily modified cars. splitfires are a common choice for racing applications.

on my splitfire box it has a graph showing a dyno comparison, an RB making 323ps with regular coilpacks, and 330 with splitfires. theres also another graph which i assume is something to do with spark or volts or something (its in japanese) but the splitfires easily outperform the comparative product.

the hks drag gtr runs stock coil packs, the only reason ppl go spitfires is cause nissan

want something like $1000 for them brand new

they must be stronger. i havent heard of anyone running new nissan coilpacks in heavily modified cars. splitfires are a common choice for racing applications.

on my splitfire box it has a graph showing a dyno comparison, an RB making 323ps with regular coilpacks, and 330 with splitfires. theres also another graph which i assume is something to do with spark or volts or something (its in japanese) but the splitfires easily outperform the comparative product.

Stronger based on what?

They are not stronger at all.

You are comparing 10-15yr old worn Nissan coils, vs a new coil out of the box, which is wrong. Unless you had brand new coils in your car, your results/testing is incorrect.

If you purchased a NEW set of Nissan coils, put them against Splitfires - you wouldnt know the difference other than one lightens your wallet substancially more than the other.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Can't you put the pistons to TDC and then do the valve seals? Or will the drop down too far to pull them back up?
    • One thing I can tell you is, do it properly the first time. If you encounter unexpected problems just let the car sit for a week or two if you have to get some other parts or figure stuff out.  I'd have said go and use as many OEM parts as possible but since you want to change the turbo later on a custom kit is probably the better choice. Since I have no experience with RB25 just compare parts diagrams and images before buying a line kit and it should be easy to see if it has everything you need. Amayama has very good parts diagrams and part number lists, that is what I used a bunch to figure out what I might need. And don't forget to plan ahead and possibly renew other stuff that's easy to get to while you're in there doing the turbo lines. Happy wrenching
    • Update 4:   Hi all, good news. Engine is running and all the gaskets and seals seem to be working as intended. No leaks so far, even the JB Weld seems to hold. I flushed out the old coolant a few times and put in fresh coolant, not Nissan stuff, I decided to try the Ravenol Protect FL22, they claim it works for a wide variety of JDM cars and the opinions on it by some people were pretty good. And it has the nice poison green color! And man am I glad I bought a coolant system tester earlier this year, vacuum filling works wonders on this engine. I can definitely recommend this to anyone still doing it the old school way. All you need is compressed air supply. Will have to do a small test drive as soon as I can, I removed the gauge cluster again as the tacho needle was still bouncing around a bit but it was much better than before already.  I also found some cracks on all 4 tires inner and outer sidewalls. Apparently these tires should 't be parked on for extended periods or be kept under 0 degrees during storage, which I did not know. Clearly the previous owner didn't look into those details either, he probably bought them just cause they are cool semi-slicks. I'm just wondering how tf I am supposed to reach 30-80 degree tire temperatures on the public road consistenly, these tires were never going to work for my use case. I'll probably order Continental SportContact7 ones as these are the best allround summer tire available right now and I don't think I'll need anything crazier for now. Do let me know if you have experience with various tires and which ones you recommend.
    • You have no idea how many goddamn boxes I received these past three months haha Most have been put to use by now though, luckily
    • Not going to pretend I didn't do a bit of junky work this time around, but mostly due to the fact that some things I am not willing to spend days fixing right now, like wiring. I try to do most things properly the first time around.
×
×
  • Create New...