Jump to content
SAU Community

Recommended Posts

Hey guys,

Got a Motokhana on Sunday and decided i should fix my handbrake.

When i do like 70km/hr and pull the handbrake nothing really happens. The car slows down alittle but the rears dont lock. Iv'e tried adjusting the nut near the handbrake and that doesnt fix it at all.

Iv'e taken the rotors off and see two screws but they dont look like they do anything.

Any idea's? New handbrake shoes?

Thanks Luke

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/
Share on other sites

i had a similar problem, whats happening is your shoes are slightly in contact with the hub... which is normal.. but your cable is so tight that your just pulling them on harder instead of them grabbing... heres how you fix it.

take off your rear wheels.. you will see a rubber grommet on each disc.

remove the grommet, move the hole to the bottom and look in with a torch... you'll see a gear type thing. move it with a screwdriver locking up the brakes completly, then back it off until you can start to move the disc by hand (bout 3 clicks), then back it off another 2 clicks. your handbrake at the back is now properly adjusted, so its all up to the cable now

adjust your cable at the hand brake so you only have a bit of movement in it before it actually engages.

a tight cable will hold the shoes against the hub slightly, when you go to pull the brake, your just pulling the shoes on harder... they dont have that sudden grab that locks the wheels.. so if the shoes are adjusted properly at the back, they will have a bit of clearance, and with the cable adjusted with a bit of slack.. your handbrake should lock with very little effort.

cheers

Linton

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4448504
Share on other sites

i had a similar problem, whats happening is your shoes are slightly in contact with the hub... which is normal.. but your cable is so tight that your just pulling them on harder instead of them grabbing... heres how you fix it.

take off your rear wheels.. you will see a rubber grommet on each disc.

remove the grommet, move the hole to the bottom and look in with a torch... you'll see a gear type thing. move it with a screwdriver locking up the brakes completly, then back it off until you can start to move the disc by hand (bout 3 clicks), then back it off another 2 clicks. your handbrake at the back is now properly adjusted, so its all up to the cable now

adjust your cable at the hand brake so you only have a bit of movement in it before it actually engages.

a tight cable will hold the shoes against the hub slightly, when you go to pull the brake, your just pulling the shoes on harder... they dont have that sudden grab that locks the wheels.. so if the shoes are adjusted properly at the back, they will have a bit of clearance, and with the cable adjusted with a bit of slack.. your handbrake should lock with very little effort.

cheers

Linton

This worked!!!! Thank you so much mate. :glare:

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4450460
Share on other sites

no worries... and as for the shoes... ive been in the game for 7 years now... except for drum brakes... ive never replaced a set of handbrake shoes.. and an r34... a highly doubt you will be replacing the shoes in your life of the car.

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4451670
Share on other sites

no worries... and as for the shoes... ive been in the game for 7 years now... except for drum brakes... ive never replaced a set of handbrake shoes.. and an r34... a highly doubt you will be replacing the shoes in your life of the car.

This man, he knows...

Hand brake shoes don't really "wear out" unless you're one of those gumbys who drives around with the hand brake still partially on...

Most of the time, when you pull the hand brake on, the car is already stopped, so there isn't really any "wear"

Edited by MBS206
Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4451987
Share on other sites

I have no idea if my car has a LSD, i jacked one side up and i could turn the hub fine and make adjustments. As for the "worm screw" to make the shoes tighter or looser, screw it up for tighter and down for looser....also if you see an actual flathead screw in there, leave it alone, trust me.

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4458282
Share on other sites

I have done this adjustment, but must have not backed off enough, I think 5-6 clicks from shoes locking the hub. Anyway, the shoes must be naturaly rubbing to much as the hub and wheel heated up fairly hot. I could move the hub easily enough once adjusted, but you could hear the shoes move with the hub a little till they hit the shoe stop pin. Just thought I'd mention it so peeps could be aware this can happen. Or maybe I just didn't put the brakes back together properly. :D

Link to comment
https://www.sau.com.au/forums/topic/258781-handbrake/#findComment-4458784
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks for all the replies fellas. Gonna finish putting it back together and see how it handles the set up. If it starts pinging it’ll be parked.
    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
×
×
  • Create New...