Jump to content
SAU Community

Recommended Posts

  • Replies 53
  • Created
  • Last Reply

Top Posters In This Topic

location ?

is it a full car ?

any special parts on it may grab interest ?

Car is in Sydney has a front mount cooler, ems computer ,bov,3.5inch turbo back exhaust,pod filter and t smart boost controller

Badges are gone already took them off while back for pics go into whole car sales photos in there as selling whole car but seen if any interest selling parts as no interest buying whole car offer reasonable offers and may consider

Need more interest in parts before i decide weather to strip or not engine $3500 any one interested auto gear box $600 Skyline wheels $500 R34 Turbo $500 skyline rolling shell good condition $3000 front mount cooler with pipes $300 and other parts but need a lot of interest before decide weather to strip first

Pics of full car are in whole cars for sale on skyline australia trying to sell car whole but no luck so far so looking at stripping a perfect condition car just looking at interest atm Exhaust can't remember brand but sounds nice 3.5 inch exhaust.

im interesting in passenger side power window switch and dash piece.

this is what im after and will take both drivers and passenger side as long as there is no marks on it

16122008053-1.jpg

both arts to be posted to melbourne.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...