Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

haha shit hey.. :rant:

bought some new snap on gloves today when the truck arrived.. impact mark 2 gloves..

oooh sex..

for ur best application they must be c*m resistant :)

Oi oi oi

I need you cr38tive bunch to think up a good set of plates for me to get :)

Ive been sitting @ my desk for ages tryin to figure out what i can get but coming up with nothing, my options are limited as i wont be spending $2k and gettin prestige just the personalized 3x2 or 3x3.

Ill ignore the first few reply's that you have because i can see at least a few smart ass comments about boats and other hilarious things :rant:

The only one I can get that makes me laugh is NAR34

Now gogogogo pump out some killa ideas

Woooooooooooo

I don't know where and when that is, durrr!

7:30 thats 7:30 or 19:30 at night meaning PM.

and its at baskins and robins wich is a ice-cream shop located on moggil road, thats the monster of a road linking west brisbane.

and there address is:

Baskin Robbins Chapel Hill

Shop 4, 626 Moggill Rd

Chapel Hill, QLD, 4069

and if you dont know where that is, its in the small shopping complex opposite the real estate place or the shell servo.

and if you cant find it, u must be retarded.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I'll get one of these also just for giggles
    • I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
×
×
  • Create New...