Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Good luck! Did it snap? :(

I meant that I'm hoping that I'm not the one who causes the valves to get munched up after I've chnaged the bellt :P it hasn't snapped, but it's overdue and I won't be at all surprised if it's skipped a tooth or two. My car is running like absolute shite lately.

Speaking of which... anyone seen or know of any good deals for air/intake/engine hoses/lines? Some of mine really need replacing. Going to change my oil pump next service, and maybe my fuel pump.

Edited by Isola

If only our IT people felt the same way!

There's probably a reason they are stuck at 1st level support in a govt organisation :P.

I wouldn't cross fingers, it makes it hard to put bolts in

I normally just use my mouth...

I meant that I'm hoping that I'm not the one who causes the valves to get munched up after I've chnaged the bellt :P it hasn't snapped, but it's overdue and I won't be at all surprised if it's skipped a tooth or two. My car is running like absolute shite lately.

Ahh good. You'll be right, it's not a particularly difficult job. There's marks on the cam gears and the plate behind em to help you get it all lined up right.

Speaking of which... anyone seen or know of any good deals for air/intake/engine hoses/lines? Some of mine really need replacing. Going to change my oil pump next service, and maybe my fuel pump.

I bought like a 10m roll of fuel hose off ebay to redo all my fuel lines. It was good quality sh*t and way cheaper than buying it from a local rip off merchant.

All the specialised intake/engine type ones I got straight from nissan (it helps to have the part numbers). The majority of them are pretty reasonably priced, but it does add up if you do a lot of them. You could also look at the silicon kits off ebay, but I don't know if they do them for a 20. They didn't do em for a 25 when I looked.

Disappointing form tonight, two events in two nights too much for you?

Good news though, my phone has been shipped :)

drove past around 9pm, nobody to be seen

figured a decision was made the night before to give it a miss this week

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • If your tuner can't make the car idle like factory, I'd get a new tuner. These injectors are fantastic and I'd have very serious concerns about a tuners skill set if they couldn't get them to idle well. 
    • It's highly likely you will find something. Alternatively, a quick design and order online from chaina and you'll have a perfect solution
    • Idle Lambda target is off by .4 but I reckon the VE table is not correct. If my tuner has no issue using these injectors I will keep them, they are good quality after all
    • I already have an Apexi. Just wondering if it is worth putting in something new since the Apexi is likely well over 10 years old, if not 15. I know the injectors work but they already run at less than rated fuel pressure to make them work properly and idle is basically 1% duty cycle or less. Could be better
    • Nice, I would never have thought in that direction. The actual motor is a cylinder....I wonder if there are any cylindrical heat sinks with the right ID  (and if there is clearance to other components). I think adding airflow is still a thing as well....will check it all out next time it is in the air. Wish I had a hoist...
×
×
  • Create New...