Jump to content
SAU Community

Recommended Posts

Hey all,

I know this has been asked a lot but about a day or so ago i noticed that my oil pressure guage is showing 8 and over (going past the last mark on the guage) should i be worried. I thought i may have had something to do with my white face dials getting installed and them buggering up the needle but they didn't cause it was fine after getting the dials installed.

I have not checked my oil yet, i will do that, i have only had the car for a month.

Cheers

Kris

Link to comment
https://www.sau.com.au/forums/topic/26561-oil-pressure-very-high/
Share on other sites

Kris,

Really high oil pressure is usually due tot he wrong grade of oil being used.

What is the pressure at idle when warm? And what it is at cruising speeds when warm?

If in dought, dump the oil and filter and change it to something the guys on here recommend.

Cheers

Jayson

I would suggest it's the sender. Disconnect the wire from the sender and see what happens to the gauge. Then try earthing the wire.

(had a similar problem in my R30 - oil pressure without the engine running, just with key in 'ON' position)

sounds like the factory gauge/sensor playing up as you mentioned it only just started happening, i.e it was fine with the same oil....

but check oil to see level, and for contamination (water or fuel etc.) and buy an aftermarket gauge for more accurate indication.

if u r oil pressure is realy high ( have it checked with a good pressure gauge ) the pressure release valve maybe stuck , its on the oil pump .

if u r gauge is reading right 8=112 psi thats to high .

  • 1 year later...

My Oil pressure reaches high's only in the mornings when car is cold. I hesitate to drive because the needle just keeps rising unless i put the car in neutral wait for it to drop then try driving again, is this normal

after engineis warm it sits in the middle.

My Oil pressure reaches high's only in the mornings when car is cold.  I hesitate to drive because the needle just keeps rising unless i put the car in neutral wait for it to drop then try driving again, is this normal

after engineis warm it sits in the middle.

Normal , the oil is too thick when cold .

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes I can see how that would put you off HFM, especially with the price of good quality brake fluid. From what I understand it as you say the BM50 is the standard BMC for a R32 GTR, I must admit I would like to go far a Genuine Nissan BM57, but lack of cash prevents that at present. With the price being so close between the genuine BM50 and BM57 a BM57 New it seems a better choice as you gain that 1/16 bore size with the BM57, I would be interested in how much difference you feel with the BM57 fitted. I am going to take SteveL's advice in the short term and see how much actually comes out of that proportioning valve vent and save up for the Genuine Nissan part. Thanks for clarifying the HFM failure
    • Thanks mate. I just got the post inspection 1/2 done from state roads when the starter motor packed up, either that or the car alarm system is having trouble.  OEM part number 23300-AA112.
    • Hi, I though I was coming to an end in finding a replacement starter motor for a rb25de neo. I came across a starter motor from Taarks and a message below stating: Direct fit. 11 Tooth count. All below part numbers have been superseded to 11 teeth. Can some body shed some light on going from 8 teeth to 11 teeth apart from 36-month / 25,000 km warranty for passenger vehicles to 12 Month Warranty. Compatible with the following Nissan part numbers: 23300-20P00 23300-20P01 23300-20P05 23300-20P10 23300-20P11 23300-AA111 23300-AA112 23300-AA300 23300-08U10 23300-08U11 23300-08U15  
    • Low battery? Maybe check capacity? I know first-hand, on BMWs if your battery drops below 80% capacity, it starts causing strange issues.
    • 8.5 +37 = should fit rear, but I think it'll hit on front. What you want is low 30s/high 20's front, mid 30's rear. That 17" screenshot you posted looks good, I'd run it on my R32 (but that's long dead now). For tyre sizes, my rule of thumb is: 8': 235, 9": 255. But that's just my opinion. Nismo sizes: 18x8.5+35/18x9.5+38 is a good starting point.
×
×
  • Create New...