Jump to content
SAU Community

Greddy Emanage Blue


Recommended Posts

hi all, I recently bought a greddy emanage blue for my r33 gtst. It came with the plug and play harness for the 33, got a fmic going in this week. My current tune setup is giving me major driveability problems, so I just wanted to know, is it safe to put the piggy-back on my car now to see if it runs any better?

Or should I just wait till i take it to staus to get it tuned with the front mount on?

And If I plug it in now and unplug it, will it cause problems?

Any info appreciated..

cheers

Ben :D

Edited by Benzino33
Link to comment
Share on other sites

plugging it in and trying will not harm anything provided you dont go boosting here there everywhere but i advise against it just in case some nuffy has screwed the timing side of things up...

Link to comment
Share on other sites

plugging it in and trying will not harm anything provided you dont go boosting here there everywhere but i advise against it just in case some nuffy has screwed the timing side of things up...

Yeah I called u guys today and u advised against it, coz i dunno wat tune its running, so i'll jus leave it till i bring it down to u guys, and does it matter if i have a manual or electronic boost controller?

i'll call up soon.

cheers

ben

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • And lower chances of a divorce, hookers & coke much higher chance, a bit lower are strippers & coke.
    • Been slowly chipping away at it when I've got time. Tried to get the box in with the converter but worked out that the flexplate isn't the correct thickness and the converter pulls out off the pump too much (about 8mm). The flexplate for some reason was setup to use the secondary holes on the converter which had a press in nut to bolt to. I worked with Adamat performance the guys who manufacture the kits and they revised the design and made it suit the factory converter holes and milled up a new one for me and is currently on its way over. Can see the differences between the two compared to the orignal design which is in the post above. Once that's here the box can go in for good. I dummy'd it back up to get tailshaft length and is currently with Hardy Spicer to sort that out. Unfortunately won't get it back until late Jan Have been working in the boot lately getting it all a bit nicer and useable. Painted it with sound deadener and cut out a new boot floor from 18mm MDF so I can put a pram or my tool bag in the back. Have marine carpet coming to stick onto that and then also cut a piece to cover the battery. Once ive stuck the carpet in and all cleaned up ill pop the fuel system back in. Need to order 2 new Walbro 525s to replace the 3x 460s. Should be enough fuel for the new setup and run a bit cooler as well having more volume in the surge tank and less heat.  Have also ordered some sound deadener to put under the carpet. That should be here next week and I'll start putting it down on the floor, doors and roof. Hoping all this effort will make it a nice streeter with ability to daily if I want to.
    • It's only money. This arrived for mine yesterday 
    • Unfortunately my car was stolen in the last few weeks while I was away. Car towed from garage in brisbane south. Wasn’t running and unregistered but good condition white 1994 series 1 r33 gts-t. Black 17inch kakimoto rims, fujitsubo ti exhaust, gtr drivers seat, hybrid fmic, standard body with m spec front bar.  reward for information that leads to recovery.    thanks
×
×
  • Create New...