Jump to content
SAU Community

Recommended Posts

I plugged in a cigarette lighter powered air compressor, and it stopped almost as quick as it started. Now the cigarette lighter doesn't work, I assume it's a blown fuse.

But looking at the fuses located under the bonnet, near the battery all were okay, so I assume there must be a fuse for the cig. lighter inside the dash somewhere?

Any suggestions?

Link to comment
https://www.sau.com.au/forums/topic/269334-cigarette-lighter-fuse/
Share on other sites

check to the right of your peddles

this pic is of the G35 (left hand drive) so filp it around and you have ours. (i think)

Thanks V35 Paul, it was where you said. After you pull the flap off, the fuse for the cigarette lighter is just to the left of the impliment provided to pull the fuses out, the 15 amp one.

Had to get some help from my a Japanese teacher at school to save me pulling them all out to check which one had blown.

All working now.

  • 6 months later...

Sorry to bring this thread up again but I am having trouble finding the lighter fuse on my car - a 2001 250GT sedan.

I can't seem to find the fuses as shown in the above diagram and while I found some fuses in the battery cavity, none seem to be for the lighter.

Can anyone advise where I should be looking for the cigarette lighter fuse on the 250GT sedan?

Hmm still don't seem to be able to find it.. Unless I should be pulling apart under the dash.. Found the computer cable and the home it lives but can't find fuses?

*Looking at Chris Rogers* Chris you are around these everyday.. Are you able to help??

Hmm still don't seem to be able to find it.. Unless I should be pulling apart under the dash.. Found the computer cable and the home it lives but can't find fuses?

*Looking at Chris Rogers* Chris you are around these everyday.. Are you able to help??

Most 12v sockets have a type of fuse attached directly to it, so remove the socket and have a look at the bottom of it, you should see it, basically looks like a thin metal wire that will have a break in it. Its so simple to fix, had a mate that tried to use a compressor and fried his sockets, the workshop quoted him $800 as they apparently had to take the whole dash out blah blah etc. I called BULLSHIT on it, told my mate what to do, so he ended up replacing the sockets himself for a few dollars.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...