Jump to content
SAU Community

Recommended Posts

had a search and had trouble findin anything, just wondering if anyone is running 10" wide rear rims on their gtt or gt r34, wasnt sure if theyd actually fit on there or not? My cars fairly low as well, could be an issue, so maybe have to go for 8.5" but input is appreciated.

Link to comment
https://www.sau.com.au/forums/topic/271530-10-wide-on-34-non-gtr/
Share on other sites

Yes been done on a r33 gtst no problem NYT SKY had 19" Hiros on his.. gtt uses same offsets.

no problems you say? so 18x10 +15 will fit piece of piss eh?

it all depends on the width/offset and tyre sized used, i dare say you will need a guard roll at the very minimum, and depending on the offset, you might need to use a stretched tyre to clear the guards.

I dont have the exact specs, but a mate of mine has a R34 GTT with 11" tyres on the rear, & the car has been lowered an inch & a half all round i think it is. He has no problem with the tyres hitting the guards, but he has rock hard suspension so it doesnt impact on bumps. The tyres sit just outside the guards, but they look just right :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...