Jump to content
SAU Community

R33 Diff Needed

jazz90

By jazz90,
in Classifieds

 Share

Recommended Posts

jazz90 Contributor

jazz90

Posted
Posted (edited)

hey everyone

i am in desperate need for a new diff to fit my nissan skyline r33 95' mine has gon in my car so i need one please if anyone can help me out call me or txt me or write back id very much appreciate it

0401010189

thanks all

jazz

Edited by jazz90
Link to comment
https://www.sau.com.au/forums/topic/272340-r33-diff-needed/
Share on other sites
  • 3 weeks later...
  • 3 weeks later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      It's not any meta data. They have scraped images from everywhere, and then use AI to compare your photo to other photos and work out where you are.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      I just looked at my camera phone settings, apparently I have "not allowed" for location  Will that stop that app?
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Can you not just turn it off on your phone if required? I remember a brief on this, well, I remember the brief, not what to actually do. LOL
    • Komdotkom
      Forced Performance Hta Turbos

      By Komdotkom · Posted

      Thanks for posting, your engine bay looks tops. I'm fairly sure you posted the wrong video though, I think you were supposed to upload the one from your "private test road" where it's banging off the limiter with the gate open?
    • MBS206
      Stagea obd II low voltage

      By MBS206 · Posted

      This is something to be careful of. I did a bit of digging on the NM35, as I spend a lot of time on near brand new cars and CANBus related stuff, which uses the same "OBD2" plug for a fair chunk of making my life easy. The NM35, does NOT support OBD2. The data pin is actually on Pin3, which is a manufacturer specific pin, and requires Consult3 to connect to the NM35. Your low voltage, is either because the NM35 doesn't have 12V to the constant power pin on the J1962 (OBD2) connector, OR, it is attempting the standard comms, (CanBus, K Line, etc) and can't see any voltage on those pins. Some people have had success accessing SOME data from the vehicle on OBD2 specification, using a module that supports KPW. My assumption, like Duncan has stated, it will likely actually be JOBD, where there is some cross over with the OBD2 and JOBD standards. Note, lots of "OBD2" dongles, do NOT support KPW, which is what you need for a lot of Japanese vehicles of this era (And even up until recent years!), EG, Subaru, Suzuki, etc.    The end of this thread is probably worth a read, as some people did find a way to get a display up in the NM35 recently, looks like someone implemented all the stuff needed to make it work. (The right protocols).  
×
×
  • Create New...