Jump to content
SAU Community

Recommended Posts

My 33 has been retired for weekend duties since buying a bike and gets limited usage which is making the battery constantly run flat.

I've a car alarm which i think is a large contributor to this and to combat it i've got a little car charger i plug into the mains to charge her up but this useless if i crash away from home which i found out first hand at the weekend!

Thank god for roll starts & the hill i used!

So anyone got any tips on how to combat this? Unplugging the battery or anything else?

CHEERS!

Link to comment
https://www.sau.com.au/forums/topic/274021-battery-running-flat/
Share on other sites

How is the alternator? Is it charging correctly? If it is overcharging (crook regulator), it will fry the battery to the point where it basically is incapable of retaining any charge.

And how old is the battery?

It's a year old after my last one died a got a brand new one put in.

Not sure about my alterator how would i check for issues with it?

Since the battery has run completely flat i've only been able to start the cat after a full 24 hour charge up.

check the circuit for a poor earth (leak) or get a battery terminal switch

Battery terminal switch? Now we're talking. Is that a common thing? As in will it be hard for me to track someone down to do it for me?

mine had similar issues. there was nothing wrong with the alternator etc. but when i changed battery the problem immediately went away. just wasnt holding any charge and would die after listening to 5 minutes of music. my new one is exactly the same battery. has lasted me 6 months so far.

upgrade i say - get an optima battery, as well as all the suggestions above

i've put a kill switch in mine for all my equipment. You could easily put one in for the battery itself but then you'd have to reset your head unit and clock every time you jump back in.

don't know if it'll help, but heres some optima and kill switch info on my setup: http://www.skylinesaustralia.com/forums/Op...ug-t228221.html

upgrade i say - get an optima battery, as well as all the suggestions above

i've put a kill switch in mine for all my equipment. You could easily put one in for the battery itself but then you'd have to reset your head unit and clock every time you jump back in.

don't know if it'll help, but heres some optima and kill switch info on my setup: http://www.skylinesaustralia.com/forums/Op...ug-t228221.html

Top work cheers!

Battery terminal switch? Now we're talking. Is that a common thing? As in will it be hard for me to track someone down to do it for me?

You can do it yourself, its just replacing a battery terminal. Supercheap have them for about 10$ or so (cant remember exactly what they're called but they allow you to disconnect the battery for working on the car without having to remove terminals)

Take your battery to supercheap they can test the battery condition also for you (they test all stock going out). You'll find its probably ok and just a wiring fault

mine is having pretty much the same problems, changed the alternator and battery, now have a red top optima, during the hot weather it wasnt really a problem, now that its cold i cant keep it charged, i now have to use the old odysey battery that i replaced to jump start the car every morning and when i leave work every night, its pissing me off.

^^^can't stop looking at Brett's Avatar...

oh yeah... back to the thread...

If the battery has gone, it might still have a warranty on it (whilst you still have a receipt). Usually 1-2 yrs Wty

^^^back to the Avatar...

battery going flat after 1 year?? that doesnt sound right mate.. what brand is it?? with batteries they have a pro rata type warranty for 4 years... ive had many a weekend warriors and not had a drama with them going flat...

check your alternator charge rate.. have the car running and put a multimeter across the terminals, if its 14.2v.. happy days... under 13... alternator stuffed

check the levels of your battery, the electrolyte level should be just at the bottom of the plugs.. or atleast, completly covering the cells.. if thats ok...

check for voltage leak... put a multimeter on the terminals with the car off... check the voltage (should be 12v or so) and watch to see if it slowly goes down.. so maybe come back and check it every 10-15 min for a few hours) if its still 12v, then volts are not escaping via something using them..

if everything above is fine... get someone to start the car while you are checking the volts... if its showing 12v at the battery then drops to lower than 5v when trying to start... the battery is farked.. it has a surface charge, which can run your dash lights and everything, but doesnt have the guts to actually crank the engine..

if you said the battery was original and untouched... then id point at the battery straight away... but if its only a year old... im pointing at a gremlin somewhere.

if your car is a monthly warrior... then you can get trickle chargers... which supply a low current and low voltage, just to keep the battery topped up... you can use them 24/7 as they shut off when not needed.

cheers

Linton

im amazed by that avatar aswell... not because she fell into the water... but because of old mates reaction... or lack of... he doesnt even flinch. haha.. models... hes either too stoopid to realise whats happened... or has too little brain capacity to walk in a straight line and be aware of whats going on a round him.

Something I learned last night - my nephew's car stopped on him recently. When we got it home, it managed to fire up, but only had 11.5V at the battery. Immediately suspected pooped alternator.

Anyway, went to fit the replacement alternator last night, noticed the belt seemed a bit loose, and the -ve battery terminal was loose. Tightened them both up - va-voom 13.5V with headlights on.

So, the point of this story - is the fan belt tensioned correctly, and the battery terminals done up tight?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You can use your VIN to look up the factory part number somewhere like amayama, and then look to order new if necessary. https://www.amayama.com/en/genuine-catalogs/nissan Depending on price you might want to rebuild instead. @GTSBoy I had an interesting insight into US market parts when the Titan rear calipers were sticking. New calipers were dirt cheap, about 20% more than a rebuild kit....they are just considered throw away maintenance items
    • Funny, but really not funny. Thank god (most) f the world has moved on since then
    • Lots of votes for driving onto a plank first; that is the quickest way I've found, 25mm is enough for my case but that will vary by car It also depends where you are going for. On the 32 I can get to the rear diff with my floor jack if I do that end first, and get it up on stands. Then I lift the front from either front tow hook as high as needed, also onto stands. Sometimes I need a small lift on the other tow hook to get it level enough If I do the front first I can't get to the rear diff because of the angle of the car Other options are getting to the front mount of the rear subframe from in front of the wheel (if only lifting one side, or just do both which is a bit of a pain compared to one lift from the diff), or also the gearbox cross member mount on the driver's side if you are  just trying to lift the driver's side. I This is the jack I use; it says 75mm clearance but of course that is only on the lower section so if you have to reach too far in like the diff you still get stuck. https://www.snapon-bluepoint.com.sg/category/Floor-Jacks/product/Floor-Jack,-2-Ton-Low-Profile
    • On the bright side, the weather will turn much nicer for working outside shortly....sounds like you might need to start on a neighbour's garden next
    • Ok so i will NEED to have this sensor anyway even with Nistune (or standalone ECU) https://justjap.com/products/genuine-nissan-boost-pressure-sensor-evap-control-system-fits-nissan-r34-skyline-c34-nm35-stagea-pnt30-x-trail-rb25det-vq25det-sr20vet?currency=AUD&srsltid=AfmBOoqfxX48bW9bEwH62orcNhtBfp7ekAL0C9Ca89ySFGUiBzXfXeze Is this the correct one? And this is only thing i need? No other "things" connected to the sensor or something? I do have the wiring.
×
×
  • Create New...