Jump to content
SAU Community

Recommended Posts

I know this a really old thread but its as close as I can find to my problem.

I'm installing a an M60 into my car and I cannot get the boot release to fire.  If I Hold button 2, for 3 sec and I get four flashes of the alarm but no pulse from CH2, Output wire.  (This is what I expected, although the manual is very light on) I checked if CH 2 was an earth switch wire but again nothing. 

Struggling with this. Does anyone know the problem?

  • 10 months later...

Found the problem. I had wired +12V to the wire and it had blown a chip in the alarm. The manual only gives a small cryptic reference to the wire being an earth by putting a (-) in one place. Thanks to the guys at Mongoose for replacing that chip. They were very helpful and with a relay in place the system now works well.

  • 3 years later...
On 12/16/2014 at 10:08 AM, Vapo27 said:

I know this is a very old thread but just in case someone else needs it, to turn on/off the turbo timer for the m60 and I believe m80, you have to press both button 2 and button 3 simultaneously while the ignition is on.

Also, here are the programming instructions

(Note: this is from my m60 manual)

Drivers door must be open

Within 15 seconds of opening the door (note: Seems to really just be within de-arming the immobiliser), turn the ignition ON/Off the number of times for the programming feature (e.g. 3 times for remote code learning)

Siren will then chirp the same number of times as the programme number.

Press button one to turn the feature ON siren chirps once, lights flash once.

Press button two to turn feature OFF siren chirps twice, lights flash twice.

Leave system for 10 seconds system quickly chirps 3 times (lights flash 3 times) to show exit of programming mode

Ign on/off Feature Button one (on) Button Two (Off)

3 Remote code learning

4 Ignition Door Lock ON OFF

5 Siren Chirps ON OFF

6 Turbo Timer Each press = 1 minute

Siren chirps for minutes set, max 5 mins

7 Last Door Arming ON OFF

8 Door Diagnostics ON OFF

9 Engine Immobiliser ON OFF

10 Siren or Horn Siren Horn

11 CDL Pulse 0.8 Sec 3.5 Sec

12 NSW Siren Timing ON OFF

(CDL = Central locking)

Cheers

Vapo

Necroing this thread in 2025 to say thanks! The Manual for the m60 still has the wrong instructions and says to only press button 2 with ignition on.

You are a champ, thank you.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...