Jump to content
SAU Community

Recommended Posts

Hey guys, pulled a kit off my current R33 project car to slap on a kit that's more to my taste and am selling the ones I took off the car... no idea what kit/s they are but I'm selling a Front bar, Rear bar, side skirts (pair) and a spoiler.

full kit is plastic, not fiberglass.

Side skirts have a crack in each of them in the same place that I didn't even know was there till I pulled them off the car, easily repairable.

Spoiler just needs a new coat of clear as it's started peeling.

Rear bar is in clean neat condition.

Front bar is just as good. lights included.

Located in Launceston Tasmania

make offers and if your keen on them I'll grab postage costs for you.

Will post more pics after work and even more if required.

53305720.jpg

p6150357.jpg

89152722.jpg

Link to comment
https://www.sau.com.au/forums/topic/276465-selling-r33-bodykit/
Share on other sites

Hey guys, sorry I've been real busy workin on the car over the weekend.

W0rp3D the Front Bar comes with the grill but the grill needs some TLC or fresh paint / touch up.

I cannot yet reply to PMs =(

Had lots of offers for the spoiler.

I'll call around and get the postage costs for the enquiries I've gotten so far and post them after work =) (Monday)

ok guys, postage / courier from my place to yours is up around $300 per item =(

Where as airport to airport is from $20 to $35 anywhere in aus but means you would need to pick items up from your airport or i could possibly arrange pickup from airport to your door, not sure.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...