Jump to content
SAU Community

Recommended Posts

Hey all ............

i need a little help my R33 Gts-t auto

after i gave it a little bit of a hard time on wednesday night

it has started slipping

1st gear dont slip nor does 2nd that i can noitice

and i dont think 3rd does either

but once in 4th-O/D is slips like nothen else

Could really use some help becasue its only started slipping afteri over headed it down the 1/4

thanks in advance

Andrew

Link to comment
https://www.sau.com.au/forums/topic/276659-auto-gearbox-is-slipping/
Share on other sites

what im worried about seen its done this ..... how long does it how until it shits it self ........ becasue im looking at upping the boost this week

You're not going to have a catastrophic failure, she'll just slip like mad until the band gives way completely then you be missing that gear.

If I were you, I'd leave the boost as is and baby her until you sort the issue.

Either drop the manual in or replace the box with a second hand one for now, depending on your financial situation.

My clutch pack fried too, and I found a secondhand auto box for $350, pulled the old one out, chucked the replacement one in, and turfed the old box.

Awesome thing about everyone converting to manual is that complete boxes are cheap as chips.

picked up a 2nd hand auto box for 150 end of last year after i killed my old one. much cheaper to just buy another box and swap it rather than pay for rebuilds etc

also look into a shift kit and trans cooler, or you'll just kill the next one

Edited by stenve

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...