Jump to content
SAU Community

Recommended Posts

Hey all, I have recently become a member of the skyline owners club purchasing my first skyline from a member on here. Since my licence is still suspended until mid august ive been fixing a few little problems the car had like the head lights and what not. My issue now is that when i turn the a/c on or even just the fan it doesnt blow through any air at all and its got me stumped on to what could cause this. Ive checked all the fuse's and they are all ok. I have checked all thew connectors behind the stereo/climate control and they all seem to be plugged in. Has anyone else had this problem and what they did to fix it or how much it cost them for a auto electrician/air con place to fix?any help will be most appreciated.

Thanks

Daniel

Link to comment
https://www.sau.com.au/forums/topic/280972-help-no-ac-fannothing/
Share on other sites

  • 3 weeks later...

cheers for that,followed the guide and got error code 21 when it started up which is the outside air temp sensor. then when going thru the fan and vent test nothing came out and i couldnt hear anything engage or anything,any ideas on how to fix or auto elec?

Here's a translation of the fusebox.

post-51527-1250076182_thumb.jpg

If still no air, replace the following with brand new fuses: both 15amp Fan Motor fuses (#4 & #5), the 10amp A/C fuses (#10 & #20) and the 10amp "Electronic parts" fuse (#23)

yep done that replaced all the fuse mentioned,will recheck them again to see if they are blown,but i doubt it as they wernt blown to start with :ninja:

Edited by funki_munki

If the R32 GTR climate control is the same as the GT-T's, grab the R32 GTR service manual PDF and read the Heater/Aircon section. Just will take alot of time probing with a multimeter that's all.

An educated guess if the fuses check out, is one of the relays are blown in the enginebay or the blower fan motor is dead.

what happens if you turn the fan speed up? i have had 2 cars (not skylines) where the fan didn't work on number 1 speed, but they did on faster speeds. you put it on 1 and nothing happened. i don't think the clutch engaged or anything. turned out to be some resistor thing for the fan motor. put a new one in and was all good. i think at 1 point when i was diagnosing it i pulled the resistor thing out and turned the fan on and it was on full the whole time, or maybe i shorted the wire across or something, but it made all speeds be full, LOL.

what happens if you turn the fan speed up? i have had 2 cars (not skylines) where the fan didn't work on number 1 speed, but they did on faster speeds. you put it on 1 and nothing happened. i don't think the clutch engaged or anything. turned out to be some resistor thing for the fan motor.

My old commodore was like that, common problem where the resister cage (looks like a mini birdcage with the resistorpack in the middle), no matter what fan speed you chosen, max fan speed.

  • 2 years later...

nissans are common for the fan speed resistor.. usually the max seting will work as it is hardwired so u dont get stuck.. not 100% if its the same in the skylines!

resistor cost me like 70 bucks from nissan

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I couldn't agree more. I should have started from the get-go with a NEO or solid bucket conversion. I started looking into converting over to solid lifters yesterday. Now for some reason I was always under the impression that when using the Tomei solid lifter conversion, you would also require new valves (Longer or shorter stems, I can't remember which).  But I see no mention of this on any of the Tomei documentation. It just states I need the Tomei solid buckets, solid lifter cams and upgraded springs. As my head is already built, all I would need is another set of 1000$ Kelford cams, 500$ buckets and about 4H hours of my time installing and I'm off to the races!?!? There's no way it's that simple, I must me missing something? 
    • BRUH, one of the biggest mistakes of my life..... and i've had plenty ;[)
    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...