Jump to content
SAU Community

Recommended Posts

  • Replies 109
  • Created
  • Last Reply

Top Posters In This Topic

Actually seems as the subject of you becoming an actual member has been brought up -

With the negative attitude you have shown, I'm not really sure you would be welcomed into the club anyway.

Should you decide to become a member, the committee will review your application before allowing you membership.

My negative attitude? the only attitude i've showin was to ppl who feel the need to be sarcastic when it comes to whiners and my membership when i've already explained it, apart from that it was a legitimate attempt to find a reason why/what happens when it comes to car shows/events and how come we didnt have anyone organise SOMETHING.

I now know and i'm fine with it, i really think you misunderstand. and i was only getting fed up because i felt i was repeating myself...thats all really. But if you feel the need to do it then fine do what you must.

and i understand that. so if i was a member already and brought this up would it have changed the way this seems to have turned out? a wanna-be member trying to understand something and then basically called a whiner and a tool and expect me to take it? all because i'm not a member yet?

This has blown way outa proportion it seems some ppl may have taken offence as there are thing i dont understand of yet, which was all i was trying to find out as my first impressions were not so great. It seems i am let down again. :dry:

I love my skyline and just wanted to share it with other sauwa guys as i was going to join, now i will need tobe scrutinised by the committee. Great. ;)

I have to agree with snoop on this one guys, i think people were a little too harsh on him. I for one didn't see his attitude as negative, i rather viewed it as the attitude of someone who would like to take the opportunity to get involved in things. Perhaps his methods and wording were a little bit off, but i certainly didn't see it as negative. Although im no committee member, i thought i should just say that.

Give the guy a break, effectively all he did was question why we were not involved in these big events, although i agree he could have raised the question in a different manner. However had some of us simply explained the situation to him without 'attacking' him, his issues may have been resolved easier.

Of course that is just my opinion

I've lost count of how many times this has been covered.

Imma let you finish....but imma build a 30! That will solve this issue. :down:

Sorry, trying to change the subject as conversation isnt going any where. :P

No point getting this upset about it

Guest
This topic is now closed to further replies.



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...