Jump to content
SAU Community

Recommended Posts

it only kicks in around 80kph as Aaron has said. its basically an electronic actuator (motor) that controls a steering rack attached to the back of the rear subframe and is liked to the rear of the wheel hub with a toe arm. on the R32 & S13 models it was a hydraulic setup driven off the power steering pump. it turns the rear wheels only by approx 0.7 deg from center, so if your where going around a right hand bend you wheels would be something like this:

front wheels // //

rear wheels \\ \\

when you install a HICAS lock bar you remove the actuator/rack and put a solid bar in between the two toe arms to hold the rear wheel toe where you want it.

edit: beat me with a much better diagram MIKE lol

Edited by QWK32
Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4753292
Share on other sites

HICAS is a very complex system, that is way over what most people think it is.

It helps to make a car feel shorter & more nimble, and helps to damp Yaw effect.

A long wheelbase car is easier to control but slower to turn. Rear wheel steering helps to turn the vehicle.

It has been heavily critisized for making the rear end feel loose, vauge and unnatural.

Lots of HICAS systems get taken off cars, mostly because owners do not fully understand what it is about.

It is there to make the car drive faster.

As you enter the corner the rear of the car actually gets kicked out, which reduces understeer, if you stay hard on the accelerator, as the car reaches the apex, the steering, G-sensors and throttle position will let the car "know" that it is at the apex, the rear wheels will come into phase and the car will steer straight though the apex, to take the fastest line through the corner.

It's kinda like taking a drifters line without drifting.

Your car should have the same system as the R34, which is also a model following control system.

It is pre-programmed to follow cornering models. It is not just feedback based.

If you really want to find out more about, and get a new admiration for our favorite car (sorry not the Stagea) get the book Nissan GTR by Alex Gorodji. Some of the above is taken from the book.

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4753764
Share on other sites

simple diagram

how_hicas_works.gif

i really hope it doesnt work that way, thats very dangerous!! if the rear wheels are turning in the same direction as the front wheels, instead of the opposite, then u r in big trouble if the front doesnt turn in. in an understeer situation, that would have the rear wheels turning u straight off the road!!

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4753813
Share on other sites

HICAS is a very complex system, that is way over what most people think it is.

It helps to make a car feel shorter & more nimble, and helps to damp Yaw effect.

A long wheelbase car is easier to control but slower to turn. Rear wheel steering helps to turn the vehicle.

It has been heavily critisized for making the rear end feel loose, vauge and unnatural.

Lots of HICAS systems get taken off cars, mostly because owners do not fully understand what it is about.

It is there to make the car drive faster.

As you enter the corner the rear of the car actually gets kicked out, which reduces understeer, if you stay hard on the accelerator, as the car reaches the apex, the steering, G-sensors and throttle position will let the car "know" that it is at the apex, the rear wheels will come into phase and the car will steer straight though the apex, to take the fastest line through the corner.

It's kinda like taking a drifters line without drifting.

Your car should have the same system as the R34, which is also a model following control system.

It is pre-programmed to follow cornering models. It is not just feedback based.

If you really want to find out more about, and get a new admiration for our favorite car (sorry not the Stagea) get the book Nissan GTR by Alex Gorodji. Some of the above is taken from the book.

i would have to agree, i had a loaner R33 sedan with hicas, and for a big heavy car, this thing handled quite well and could be easily thrown around. i have no idea why people complain about hicas so much. i think they hear that one person doesnt like it and calls it useless, then it MUST be. if it WAS useless, car manufacturers wouldnt be equipping cars with it.......

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4754142
Share on other sites

I think the biggest complaints about HICAS come from anyone who has a dedicated track/drift car, or frequents a track for racing or drifting. And because every second person thinks of themselves as a race car driver or drifter they remove it based on what the real race driver and drifters have said.

Personally I liked the HICAS on my old 32 but can vouch for the fact that once the tail end is out there, it's too easy to over correct because the HICAS system is also assisting the turn.

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4754451
Share on other sites

You have to love the original HICAS implementation in the R31's - it had a couple of rams and flexed the entire K-frame on it's bushes!

4WS seems to have dropped off the radar these days, possibly due to it's mechanical complexity vs. what you can to with ESP and it's broader safety benefits.

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4754683
Share on other sites

i really hope it doesnt work that way, thats very dangerous!! if the rear wheels are turning in the same direction as the front wheels, instead of the opposite, then u r in big trouble if the front doesnt turn in. in an understeer situation, that would have the rear wheels turning u straight off the road!!

open your eyes before your mouth please

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4755401
Share on other sites

i really enjoy hicas . and really notice when it comes on . eg same piece of road at different speeds . also mint for turning on hicas test and your car sits there and every 2 seconds the rear wheels move full lock (1 degree ish) one way and then other way then back to normal as fast as they can . and every one says wtf is your car doing ? "its break dancing "

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4755416
Share on other sites

Has anyone ever had HICAS work in a straight line? That sort of issue, giving the car a 'flick'? Possibly due to the wheel not being on straight...?

only when the speedo cable snapped when i was on my way home from work, hicas started playing up along with the usual heavy steering. i was crab walking up a straight road, very strange feeling.

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4755455
Share on other sites

only when the speedo cable snapped when i was on my way home from work, hicas started playing up along with the usual heavy steering. i was crab walking up a straight road, very strange feeling.

That's exactly what I had but without the heavy steering. :) Definite crab walk. Happens at higher speeds like 80km/h and you need to steer into it and if slow down quick a flick out of it. I recently had work done on the suspension but the steering wheel is not that straight after the alignment and wondered if that had anything to do with it...? Speedo cable is all good.

Link to comment
https://www.sau.com.au/forums/topic/282242-hicas/#findComment-4755483
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...