Jump to content
SAU Community

4wd Probs


Recommended Posts

Just had my car tuned today on a 2 wheel dyno, and now the 4wd light comes on.

Tuner pulled the fuse, so I check it and its ok.

Ecu is flashing 21 times.

Seemed ok on the way home, light came on and i pulled over, turned the car off and on again and it didn't come back on. Went out after and let the car sit for a few hours and when i started it again, light comes on and stays on. Tried pulling the fuse and pulling it back in, light goes off then comes on again, tried switching car off while moving and back on again, same thing light goes away and comes back.

Does the Atessa ecu store codes? Do you have to erase them?

Link to comment
Share on other sites

Is it the Atessa ecu flashing or the Main ecu.

If it is the main then you may find it is a error witht the abs sensors due to ony the rear wheels going when on the dyo....

or

Could also be the same for the Atessa ecu...

Try disconnecting the battery then holding ur foot on the break for 30 sec to drain all power reconnect battery and see how you go.

I will dig up the Fault codes for you. Just check the flash sequence again.

Edited by 99 GTT
Link to comment
Share on other sites

Here you go mate..

R32 Atessa Codes.

1 Right front wheel speed sensor or circuit

2 Left front wheel speed sensor or circuit

3 Right rear wheel speed sensor or circuit

4 Left rear wheel speed sensor or circuit

5 ABS right front wheel actuator solenoid or circuit

6 ABS front front wheel actuator solenoid or circuit

7 ABS rear wheel actuator solenoid or circuit

8 ABS actuator motor, motor relay or circuit

9 ABS actuator relay or circuit

10 ETS control unit power supply or circuit

11 Fore-and-aft G sensor 1 or circuit

12 Fore-and-aft G sensor 2 or circuit

13 Fore-and-aft G sensor 1, fore-and-aft G sensor 2

14 G sensor power supply 1 or circuit

15 G sensor power supply 2 or circuit

16 Lateral G sensor or circuit

17 Air bleed connector or circuit

18 ETS pressure switch or circuit

19 ETS motor, motor relay or circuit

20 ETS solenoid or circuit

21 Throttle sensor or circuit

22 ETS oil level switch or circuit

Link to comment
Share on other sites

Its the ecu in the boot.

Code 21

The only thing i can think of was when the tuner looked over the car he noticed a plug that was unplugged, and he plugged that back in, that and he moved the throttle postion sensor a little.

If i do the batterty discharge thing, will i have to re-set my boost controller?

Cheers

Link to comment
Share on other sites

Sounds like your TPS is faulty> I had this on my R33 GTR. Same thing. The light will come on shortly after I start the car. If I Kept driving it wont come on.

If I stopped and idle abit . Boom. on. Changed the TPS after hooking up the NIssan consult.

Link to comment
Share on other sites

What sort of boost controller... I would say it would't not lose its settings.... If it did would be no good when you get flat battery....

Someone correct me if i am wrong..

If it comes back on after this then yea the sensor is probley dead...

Part_1_Electrical_troubleshooting_Attessa.zip

Part_2_Electrical_troubleshooting_Attessa.zip

Edited by 99 GTT
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



×
×
  • Create New...