Jump to content
SAU Community

Recommended Posts

Hi I own a r32 GTST, the other day I was driving along about to pull in for fuel, when all of a sudden a big cloud of steam came from under my bonnet and a big trail of coolant, after a while of searching i found a small hose had blown a hole under the intake manifold near the back of the engine, I have been searching around for a set of hoses to replace the hoses and found a set of heater hoses on ebay but they are for a GTR is there much difference between GTR and GTST heater hoses, or does anyone know where i can get a set, any help would be great.

Link to comment
https://www.sau.com.au/forums/topic/286945-r32-gtst-vs-gtr-heater-hoses/
Share on other sites

Well you asked where you can get a set - Ring Nissan.

I'd be highly surprised if you couldn't get any. I've had heaps of shit direct Nissan from new tail lights, ECU looms to injector looms and various other bits.

They aren't expensive with all items, just anything that isn't a sensor (CAS, TPS etc, they ask way too much)

Well you asked where you can get a set - Ring Nissan.

I'd be highly surprised if you couldn't get any. I've had heaps of shit direct Nissan from new tail lights, ECU looms to injector looms and various other bits.

They aren't expensive with all items, just anything that isn't a sensor (CAS, TPS etc, they ask way too much)

ha ha sorry man misread I will give them a call tomorow. Thanx

Edited by trav32

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...