Jump to content
SAU Community

Recommended Posts

Graveyard shift Dion??

i hope its a bit clear when i drive back to adelaide...this is perfect sleeping weather

OHHHH YEAHHHH! :D:(:D

Have had power out today, its back on now but heaps of areas are out ATM.

http://www.etsautilities.com.au/centric/ne...ons_current.jsp

Link to comment
https://www.sau.com.au/forums/topic/288885-hailing-tonight/#findComment-4838075
Share on other sites

jeez man u look close at these pics :D

anyways weather man dans report is the only 1 that matters, im forcasting lots of bogans taking advantage of the wet to counter the lack of power there fully sic commos have. 1 wheel peels will be happening in the north of metropolitan area and following through to the south early in teh morn.

cops will be issuing defects as always and well enjoy a nice weekend of getting shitfaced instead of driving

Edited by Inline 6
Link to comment
https://www.sau.com.au/forums/topic/288885-hailing-tonight/#findComment-4839062
Share on other sites

was working out in shed on the race car all day between the noise of the rain on the tin and the thunder it was bloody loud the whole shed lit up some times with the lightning .

but on the bright side my 27.000 litre rain water and the 5000 lt are chockers so plenty of water for the lawn this summer

Link to comment
https://www.sau.com.au/forums/topic/288885-hailing-tonight/#findComment-4839087
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...