Jump to content
SAU Community

Recommended Posts

Not 100% though.

The actuall rack bolts to the engine xmember, but the flairs on the lines that bolt into the rack.

I used a feed line off a ca18 silvia and the return was sr20 s13. Had to tweak the lines abit, its not exactly good looking but it works :happy:

  • 2 years later...

Hi

Im new to this forum, need help here, Im using Nissan Cefiro with chasis #: HA31-550500.. My steering rack is loss already, is it possible to use A32 steering rack to replace A31.. A31 is hard to find here in brunei..

Please help or kindly email me to [email protected]..

Hi Toffy,

Thank you for your immediate response very much appreciated. Looking at your response, as what I have understand that r32/s13 is better for replace/change for A31 is it correct toffy?. This HIcas and Non Hicas does it matter?

Being front wheel drive i wouldn't think they would fit , r32/s13 are a direct replacement in memory , watch out for hicas and non hicas too , pretty sure they were different

Hi Toffy

Thank you for your immediate response very much appreciated. Looking at your response, as what I have understand that r32/s13 is better for replace/change for A31 is it correct toffy?. This HIcas and Non Hicas does it matter? Which is better to use Hicas or the Non Hicas?

By the way, what type of car mostly uses r32/s13 rack?

Edited by vergaragerard

In my vague memory of last time i went hunting for a steering rack , they are all the same except for where the lines bolt into the rack . A very common conversion is to put an s14 steering rack in . Last time i put an s13 rack in my non hicas c33 (which are the same as cefiro) . However , i tried to fit the pressure line from a non hicas cefiro onto a non hicas r32 , the entry point of the line into the rack was different . Going from what i've been told , hicas racks have extra lines for the four wheel steering . I hope this helps :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...