Jump to content
SAU Community

Recommended Posts

Hey mate is the stock suspension in good condition i need the rear shocks with no leaks for rego and how much for postage to Canberra

Rears are $150 + I would guess about $25 for postage?

Rears appear to be in good condition.

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

how much for gt badges and boot badge?

cheers

Im unsure what badges your talking about.

The badge on the guard isn't a GT badge and there is none on the rear,

Sorry

Edited by JiN_MaN

Hey mate im after the aircon condenser (the thing thats like a radiator that sits in front of the radiator) if its in good condish, offer of $50

Hit me up with a texty if you can im at work most of the time so cant answer,i travel past anzac highway everyday for work so i can pick it up before 3pm or after 11pm weekdays.

0488001069

Cheers,

Jack

Edited by Jack88
Hey mate im after the aircon condenser (the thing thats like a radiator that sits in front of the radiator) if its in good condish, offer of $50

Hit me up with a texty if you can im at work most of the time so cant answer,i travel past anzac highway everyday for work so i can pick it up before 3pm or after 11pm weekdays.

0488001069

Cheers,

Jack

Sorry mate I wouldnt take the risk with it. Id say bent/cracked and not worth selling.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...