Jump to content
SAU Community

Wats Wrong Wif My Beast?


JJAY34
 Share

Recommended Posts

sup guys im not sure if this is the right section to post in but anyways. i was driving my n/a 34 today and i pulled up at a intersection and the engine started idling weird and made the whole car shutter then the engine light came on which has never happened before.has this happened to anyone before? what was it?how much to fix? and should i be worried?

thanks heeps peoples. :(

Link to comment
Share on other sites

most likely ur coil packs playing up if it started to sound like a rexi n ur engine light on... if u wanna confirm it get an engine diagnostic done n it will spit out the codes 4 ya... best bet is get a set of splitfires :( ... n at the same time sum plugs if they need changin

Link to comment
Share on other sites

Jas is right, we have both had this problem and we both put splitfires in, there awesome but expensive (about 650 atm) and if you like there are plenty of guys that will help you install them, easiest thing to do, if your not 2 far away i'll do it for you. If you cant afford splitfires there are are others that will do the job....

Link to comment
Share on other sites

update is it is at the mechanics and the mehanic cant diagnose what the problem is so i have to pick it up tommorrow morning and drive it until problem happens again then take it back to him immediately sound weird too you? do u reckon hes dodge?

Link to comment
Share on other sites

update is it is at the mechanics and the mehanic cant diagnose what the problem is so i have to pick it up tommorrow morning and drive it until problem happens again then take it back to him immediately sound weird too you? do u reckon hes dodge?

I'm going to go out on a limb and say he's a moron :happy: - if he had the write equipment he will be able to plug it into your ECU via the connector under your steering wheel to the right and it will give you a code and tell you whats wrong. Also the fact that the problem is spontaneous is a symptom of coil pack failure. A Dyeing coil pack will start failing more and more and in the early stages of failure will fail when the engine is hot or at high revs (where its worked harder and harder)

Where are you located mate?

Link to comment
Share on other sites

I'm going to go out on a limb and say he's a moron :happy: - if he had the write equipment he will be able to plug it into your ECU via the connector under your steering wheel to the right and it will give you a code and tell you whats wrong. Also the fact that the problem is spontaneous is a symptom of coil pack failure. A Dyeing coil pack will start failing more and more and in the early stages of failure will fail when the engine is hot or at high revs (where its worked harder and harder)

Where are you located mate?

Not even the right equipment, just a paperclip!!!!! All he has to do is the consult port self diagnosis with a paperclip and read Error 21 off the check engine light :)

diagnostic.doc

Link to comment
Share on other sites

Coil packs is the most common issue for R34 GT/GT-T. Get them changed. While you are at it - change the spark plugs (NGK platinum) too @around $15 each from a Nissan dealership - saves the hassle of getting to the spark plug area again later on.

Link to comment
Share on other sites

well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

Link to comment
Share on other sites

well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

"If" he is the only mechanic in the area. Buy the ignition coils from eBay or any other shop and get him to install it.

Make sure you specifically get the coils for RB NEO engines.

Link to comment
Share on other sites

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :(

Link to comment
Share on other sites

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :(

actually, my r34 had had stored the fault code primary ignition failure 21... we tested it when the light was off then tested it again when it came on ( which was litteraly a drive around the block later, lol) just to be sure and of course it was the coils.

Edited by AYW550
Link to comment
Share on other sites

well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

lol hope he didnt think u were refering to the suspension springs as in the coils :(

how often does ur engine light come on??? like 10 mins after start up n then goes away after u turn it off n back on, or go on n off every 5 mins

also does it alwayz shudder n splutter n spit the dummy n stuff or does it come n go???

ive got a set of spare stockies u could try, wack them all in n inspect the plugs at the same time n see if the problem goes away... least then u will know 4 sure if u need 2 buy new 1ns

BUT its way easier 2 just get a diagnostic done if u can... btw u might have 2 use a GTT diagnostic

Link to comment
Share on other sites

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :)

I'm calling him a moron for jerking this guy around, if he doesn't know whats wrong or he hasn't got the means or the know how to fix it then just suck it up and say so, don't waste ppl's time. When this happened to me i took it to my local mechanic and he had no freaking idea what was wrong and he admitted that he was unfamiliar with imports such as mine.

actually, my r34 had had stored the fault code primary ignition failure 21... we tested it when the light was off then tested it again when it came on ( which was litteraly a drive around the block later, lol) just to be sure and of course it was the coils.

exactly the same as me AYW550..

Because the Tester that my mechanic uses (the guy i go to primarily specialises with imports and most commonly skylines....) can show a whole list of past codes with his tester..... and then his tester can clear all past codes so there is a 'fresh slate' so that all future codes don't get mixed up...so it didn't matter if the engine warning light was on or off

mind you he was telling me that this new tester he had cost him some crazy amount (like 10 grand or something!!) for this thing about the size of a power FC, so if your mechanic uses a different one ( and lets face it, if your not dealing with imports on a daily basis your not going to have a 10k diagnostic tool lying around) then he probably has limitations to the interaction with the ECU. but by all means correct me :P

Link to comment
Share on other sites

the engine light comes on about 20 mins after driving it. when i stop it starts to shutter then the light comes on and it goes away when i turn it off and back on. i think i might just buy one of those cord things that go in my computer and if it says error code 21 i can say that it is my coils. and he probably thinks i was talking about my coils coz i just had new springs put in by him.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Got some decent progress after work yesterday and also today. Got the ECU all wired and passenger side interior all back together. Kept the wiring up nice and high to avoid people standing on it. Got the surge tank relays rewired and tidied up the pump wiring and cut a hole to bring the cables through.  I found a spare USB cable I had lying around so I decided to cut it up and see if I could use it for my CAN 1 bus. Turned out one of the pins I needed was to the shield of the cable so i cut it up and desoldered it and resoldered to the correct pins.  Had the issue with the powersteering hose hitting the A/C compressor and fan shroud. I pulled the bracket off and modified it to remove the front mounting point which now clears it all. Will keep an eye on it to see if theres any signs of fouling once it's up and running.
    • That's some good input mate. Nice.
    • So today I went well outside my comfort zone (again) to replace my valve cover gasket.  I have had a big leak over the exhaust leading to a lot of smoke and smell every time I drove it. The leak was in the rear driver's corner.  The job wasn't hard as such, just a bit finicky and time consuming.  The old gasket was rock hard and broken right where the leak was.  The leaky corner had so much sitting oil in it.  The good news to my amateur eyes was no buildup or sludge under the cover. It all looked fairly nice in there.   I haven't started it yet. I ran out of light and body when putting the coils and injector loom back in. Probs only 30min left for the morning.  I was so nervous putting the cover back on, I must have lifted it 5 times to make sure the gasket was still seated properly. God it's going to be nice to be leak free and not make other traffic light queuers think my car is about to explode.
    • Gave the Mazda it's first wash, it will need some clay, a light compound, and polish polish to remove a few swirl marks, but that will be a job for when I have a full day to get my DA polisher action on
    • Just did this job on my 32 with the boost doc kit. was quite simple to fit, hardest part was getting the rubber bungs back on the firewall. does anyone know how the heater will work now without the flap in the bend? Will I just have a heater on 24/7 now?
×
×
  • Create New...