Jump to content
SAU Community

Recommended Posts

  • Replies 134
  • Created
  • Last Reply

Top Posters In This Topic

It's Mel again,

The photos are BRILLIANT!!! Basti you should look at doing professional photography, stunning work!!!

I particularly like the oyster and prawn sexing......

xoxoxoxoxoxoxoxoxoxoxoxoxxx

lol, im too lazy. all i've done recently is meets. need to do other subject matter, which is why i loved this cruise.

jossef, you are welcome to have another ride man, i've got a time to try and beat now.

lol roman fair point i suppose on that 1 but damn was so hot the tar on the road was melting aswell as my tyres so meh!

and yep basti ill take another ride get a 2nd vid when u crack 10 min, next time u come for a run with me when i set my car up :P a year should be enough unless we do this again sooner <3

i was like damn, the downhill drop just took the rear too far.

i saw you guys were a fair distance away so i knew you had plenty of time to slow down

i don't think James saw me though and he was surprised why you would slow down that much around that corner

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Good to hear. Hopefully you're happy enough not to notice when driving and just enjoy yourself.
    • I mean, most of us just love cars. Doesnt necessarily have to be a skyline.
    • Did you pick up a manual cluster to remove the position indicator?  (Pretty sure the 34 has the gear position in the cluster, but it's been a while)
    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • 440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
×
×
  • Create New...