Jump to content
SAU Community

Recommended Posts

  • Replies 521
  • Created
  • Last Reply

Top Posters In This Topic

f**k yea, 104 in a 60 zone :3some: i was gonna go for a run but it was a pusute car so i thought i better not, but the cop was ok, he said he saw me in the 80 zone when clearly was not but i wasnt gonna argue with that... $210, oh well, paid it about 20mins after so its all good

Link to comment
https://www.sau.com.au/forums/topic/30197-darwin/page/22/#findComment-3053823
Share on other sites

well found out in the last two days im either comin back up there or too brissy at the end of the year my job prob wont be here at the end of the year, so the sinista plates may grace my car once again, this time i will be back with avengence (hmmmm 320odd rwkw) hahahaha i have to wait to find out lol

Link to comment
https://www.sau.com.au/forums/topic/30197-darwin/page/22/#findComment-3063704
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Hey ill be in Darwin from 21st of June to 3rd July.

How about a cruise on the 30th so i can have a look at some Darwin Skylines???

I can participate in the cruise in either a 4wd or Hyundai! (Dont judge me, its not my fault) LOL

Link to comment
https://www.sau.com.au/forums/topic/30197-darwin/page/22/#findComment-3134954
Share on other sites

if you want that , you will have to post in the NT section of Boostcrusing.com , as there are not enough skylines to keep this part of this site running , there are some very nice lines up here so I hope it happens

Cheers

Jaqule

Link to comment
https://www.sau.com.au/forums/topic/30197-darwin/page/22/#findComment-3136793
Share on other sites

26 the 31 Zac, pron!

I have thought about it but its a bit of work... was guoing to do a 25 because they're not so much work. But looks like i could have another RB30 soon, and it wont cost me jack so i'l probaly do a crazy RB30. :sorcerer:

Link to comment
https://www.sau.com.au/forums/topic/30197-darwin/page/22/#findComment-3153920
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...