Jump to content
SAU Community

Recommended Posts

when you say trouble starting.. do you mean you need to turn the ignition more then once and give a bit of gas whilst it idles? if so this happens to mine and i thought it was normal ? =\

Need more info. Car type ? Doe it have a computer ? What plugs are you using ? Have you reset the standard computer if thats what your running ?

its a gts r32 with stock compture the plugs are just standed ngk ones chanded a while back

I had problems with this for a bit also rough idling. Was told by racepace that it was my air flow meters. They just needed a clean. Just used throttle body cleaner in a pressure pack. Gave them a quick spray and was all good. Apparently they get a build up of shit on them. Maybe try that.

Clean AFM, good start, definately. Could be water temp sensor but I would think that would only keep it in cold start longer. Check all your earths as fuel pump, coils are severely affected by bad earth. Couldn't be fuel filter blocked as it would affect overall performance. Hmmmmmm........

could be:

cold start valve

IAC valve

AAC valve (or a combination of all 3)

fouled plugs caused by the above

fouled plugs caused by them being too cold temperature plugs

weak coil packs or ignitor

dirty/faulty AFM

and if the ecu is aftermarket, i'd say the tune needs adjusting.

also try letting the fuel pump prime properly before turning the car over. there is a small possibility that the valve in the pump is dodgy and letting the fuel drain back.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...