Jump to content
SAU Community

Recommended Posts

Hey guys,

I have a 95 Gtst 5spd and when driving there is a high pitch squeel coming from the motor.

Now at first i though it may of been the turbo, so i bought another one yesterday (had very very little shaft play in and out, none up and down)

and fitted it but...i still have the sound. The sound only comes when i am high up in the revs on full boost (about 8psi, thats what the guage says)

So first and Second gear mainly at about 4500-5000rpm and then upwards from there .... but not when i am in 5th gear foot flat at full boost

Would it be possible the BOV is leaking and making the sound? When revving the car from under the bonnet and looking at the BOV it seems to open slightly when it hits the little bit of boost

The only Mods to the car is a full 3" system, HYBRID FMIC, GFB BOV TYPE 1 i believe, GFB Atomic Boost controller, and a boost guage

any help would be appriciated

Tim

Link to comment
https://www.sau.com.au/forums/topic/306329-strange-engine-noise/
Share on other sites

What else have you done to the car recently? I'd be inclined to think it's a vacuum leak somewhere at one of your intercooler piping joins or something similar.

I had a shitty high pitched whining noise coming from where my bov meets the crossover pipe, turns out the gasket wasn't sealing it properly so when there was 7+psi of boosted air going past it, it would leak out and make a sound like air escaping from a tiny hole in a balloon.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sane enough. Remove the roof liner, because the acid will go everywhere.
    • Thanks guys, I really appreciate the help and experienced opinions.  I have spent a lot of my life working on boats so I'm pretty good with fibreglass. I'll take everybody's advice in here;  I'll cut a little more of the 2nd layer away as it's a bit crunchy rust and also it's sitting high now. Then I'll wire brush it all a bit to get off anything loose, then I'll soak the bejesus out of it all in rust converter. I'll make sure to get a little hose piece and feed it into all the holes and gaps between the roof layers. Then I'll fibreglass up the holes.  Then I'll get a pallet of filler and mix it with 3 buckets of hardener and hope that is enough to build up the roof corner.  Does that sound sane? Is one type of filler better than others for this?
    • My goals for it atm are to get it registered, respray and some mild power gains eventually... I picked up the car from an elderly gentleman near the border of NSW and VIC, its honestly a bit rough and looks like its been driven on a farm (because there was so much dirt underneath). Last week I dropped the subframe and emptied the old fuel out + added a new fuel pump (think the old one went bad from old fuel). Now I'm onto fixing a coolant leak at the rear of the engine + adding a new radiator as the old one is corroded. After that i have a new bumper, coils (as the old were leaking) and lots more
    • Welcome buddy! Plenty on here and YouTube. What are your plans for it? Good luck with the Rwc and Rego bud!
    • Love this so much! Please post a photo when you have a bike on the trailer.  I was a little bit worried about having a tow bar on the Skyline, but having it hidden behind the number plate is genius
×
×
  • Create New...