F40 Brembos With 343mm Rotors

[Roy]

Looking at selling the F40 setup that I have pieced together by buying bits off Yahoo over a period of time as car is going into storage and this setup is currently off the car so that i could have 16" wheels on the car.

The kit consists of:

- Brembo F40 calipers. Used with one rotor having been slight damage where it rubbed on the rotor. This is how I bought the caliper, suspect previous owner left off a washer which meant the clearance was not sufficient. (See pics)

- Pads - Cant say for certain what model padm but most likely ENDLESS (see pics)

- 343x32mm RDD rotors. These are Japanese rotors and are in very good health at 31.7mm thick. These rotors are perfect to run under a good 17" wheel as they are about the biggest brake combo you can run under a 17" wheel. I wanted these rotors due to the hat design and are the reason i built up this kit.

- RDD alloy radial mount. They have had a little bit of the outer edge ground off so that these GTR mounts can be used on the GTSt or GTR hub.

- Braided GTR lines, they are the 2 piece type which are found on most GTRs and a few GTSts

This setup weighs less then the STD R32 GTR brake setup!

Before installing the calipers need to have the bleed nipple and bridge swapped over to suit the direction of the rotors. Was going to do this before sending them off to be blasted and HPC coated. As you can see in the pics the seals are all in good condition, whilst the paint is in average condition with the clear coat pealing in places

This kit can be used on an R32/R33 GTSt, GTR, GTS25t and Z32s and S13/14/15s (braided line may not suit all cars)

Looking for $2200 + delivery, not a dollar under

The general components:

Right caliper

Seals

Underside of right caliper

Left Caliper

Underside of Left Caliper

Seals of Left Caliper

Rotors

Close up of fasteners. Of all the brake setups i have played with these are my pick for hat/fastener design

Back of rotor (typical to both sides)

Thickness of rotors

Alloy mounts

Pads

Lines

I also have a set of rear R33 GTR Brembo rotors. I replaced them with new Project U rotors and these have only worn 0.6mm so were only replaced because i wanted slotted.

Asking $150

[OKBANANA]

I'll take these.

[Roy]

SOLD

[4drlvr]

Hi Bud,

Is the 33GTR Rear rotors still available??