Jump to content
SAU Community

Jwt Popcharger And Z Tube


spenny
 Share

Recommended Posts

so will the pop charger be ok on my car? scotty you dont think so?

I have one stupid aftermarket tube here I removed off a 350z, you can have it if you like. I had to pry the afm out of the silicone they glued it in with. :P

Replaced it with the stock airbox and piping.

My point is, the stock airbox flows more than well enough, and the Ztube is just a piece of pipe. Keep what you have, it flows just as well, if not better, without the downsides of a pod. If you want intake noise, save an mp3 of a Lambo V12 and play it while you drive. :P

Link to comment
Share on other sites

I'd be inclined to say there is a performance decrease. Atleast there was when I used a K&N cone filter (according to my butt-dyno ;) )

Our engine bays run hot so heat-soak is a major concern.

If you're more after noise, then get something like this:

http://www.soundracer.se/?p=98

Otherwise you could get a pod filter that fits into the stock airbox.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • I live in Thangool I cannot buy E85 fuel there or Biloela not many servo's sell it Rockhampton the  Ampol in Gracemere won't even sell 98 , it's hard to own a high performance car in CQ and NQ . 
    • Sounds like a good excuse for a trip to Australia! But yeah, trying it out is probably the best way to go about it. Please report back what you find.
    • Well as I will have both S1 and S2 front parts i will see what works best out of the two. Im not fussed if i need to drill extra holes, and im a big fan of Nutserts/rivet nuts and a nice painted dome head bolt as a way to hold stuff in place where plastic clips have broken and are hard to source new ones
    • Yeah truthfully it seems like the headlight supports for the ALTIA and S2 should be the same, but they aren't. I can only guess that the grill area of the Altia bar is different to the grill area of the S2 bar. Either that or it's due to the S1 bar having an angle up to the center bar that the Altia doesn't, or something. That said, I recently bought an Altia bar myself, and I fit it over the S1 brackets and thought "Yes, this will all work fine" so even as I doubt my own words as I post, I also daresay you'll be okay.
    • Me too. Apparently the new version of Invision will allow some customisation so look forward to a 'Love' reaction and a new 'Like' icon.
×
×
  • Create New...