Jump to content
SAU Community

Recommended Posts

i installed my cd player a few wks ago and whilst doing so i lost back up power, so everytime i turn the car off, everything looses memory and resets, its driving me insane.

im sure i heard a fuse blow but i cant find where, i think i have looked everywhere.

any 1 got an idea?

Link to comment
https://www.sau.com.au/forums/topic/310881-r33-looses-memory-no-back-up-power/
Share on other sites

i installed my cd player a few wks ago and whilst doing so i lost back up power, so everytime i turn the car off, everything looses memory and resets, its driving me insane.

im sure i heard a fuse blow but i cant find where, i think i have looked everywhere.

any 1 got an idea?

Mike

I'm gonna assume that you've had the memory problem since installing your CD player

the usual cause is the constant and Acc wires crossed over (there the red and yellow ones) swap them round you should be sweet

if the above assumption is wrong the the fuse is near your right knee

cheers

when you say everything, do you mean the clock in the dash as well? if so then as bundybear said, check the fuse panel on the right hand side of the steering wheel down near where the lever is to pop the bonnet. just pull them out 1 at a time and see if they are any blown.

also might be worth pulling out your stereo and just unplugging it then turning the car on and off to see if the clock is still losing it's memory.

if it is only the cd player losing it's memory then check the wiring

The same thing has happened to my R32... My cd player wont turn on at all, the clock wont display the time at all and my aircon loses its memory also. I checked the fuses and one was blown, so i tried putting another 10amp fuse in and it blows straight away. It all started when i took my car in to get the compressor bearing fixed and my mechanic has shorted something out but i cant figure what hes done.. :no:

i have checked every single fuse in the car and i cant find a blown one, the only reason my cd player is working is cause i wired constant with accessories for the time being until i find the solution, believe me i wouldnt be asking if i could find the fault.

And yes EVERYTHING looses memory, A/C, Clock, Turbo Timer, CD Player.

sly-01 which fuse keeps blowing in your r32?

mic

you've obviously lost the constant feed to the entire dash (probably ECU, dash lights also).

I know the 32'z have a fuseable link (not fuse, they look like a loop of wire) near the battery this might have gone

with no wiring diagram 4 the 33'z I'd grab a test light and start pokn round

check the back of the Ignition switch 4 constant power (make sure plugs arn't loose 2) it'l give you an idea where 2 look

where bouts you located ?? maybe someone familiar with autoelec in your area can help

cheers

ps you know there are 3 lots of fuses ....

mic

you've obviously lost the constant feed to the entire dash (probably ECU, dash lights also).

I know the 32'z have a fuseable link (not fuse, they look like a loop of wire) near the battery this might have gone

with no wiring diagram 4 the 33'z I'd grab a test light and start pokn round

check the back of the Ignition switch 4 constant power (make sure plugs arn't loose 2) it'l give you an idea where 2 look

where bouts you located ?? maybe someone familiar with autoelec in your area can help

cheers

ps you know there are 3 lots of fuses ....

yep i know there are 3 lots of fuses, under bonnet, under steering wheel and boot. i will search for that link fuse

im in mango hill, brisbane

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
    • No, you're wrong, and you've always been wrong about this. The Nismo has 2 sets of openings. One is a real 2-way, and the other is a 1-way. There is no 1.5-way possible with the ramps that they offer. A real 1.5-way does exist. That Cusco stuff I posted is a prime example. If the forward drive ramps are, say 55°, and the overrun ramps are, say, 30°, then you will get about half as much LSD effect on overrun than you do on drive. It is real, it realy works. OK, you're slightly right. The Nismo has 55° and 45° ramps on the 2-way, so it does offer less LSD effect on overrun. But, I think that just means that they've (probably) sensibly established that you do not want actually equal LSD effect on overrun. You just want "quite a lot, but not quite as much as the drive LSD effect".
    • Just wanted to unearth this and post my baby with the new front ❤️😝 Took her to my wedding rehearsal today. Next up is getting wide skirts (after wedding)
×
×
  • Create New...