Jump to content
SAU Community

Recommended Posts

hey guys been looking around and wanted your thoughts on if its worth getting r32 gtr rims and putting them on my gtst.

as they are an inch bigger, do they push out into the guards more? or sit the exact same and push inwards as the offset is different?

also if anyone has got these on there standard r32, just wondering if you would be so nice to post a picture... :)

thanks alot for your input...

Edited by silbastian
Link to comment
https://www.sau.com.au/forums/topic/312338-r32-gtr-rims-on-r32-gtst/
Share on other sites

Your standard R32 GTS-t rims are most likely 16x6.5jj +40 offset I think. The GT-R rims are 16x8 +30 so they will EXTEND an extra 29mm out from where the edge of your rim sits now.

R33 GT-R rims would be the best bet I reckon, because they are another inch wider again, and are an inch bigger in diameter too. (17x9jj +30).

Both look great however.

-Jimmy.

Champion bloke and awesome driver on here named Reece (spelling?) drives a 32 with gtr rims.

Go to http://www.skylinesaustralia.com/forums/Te...Te-t306227.html

and its the dark grey r32 with number '32' on the side. theres heaps of photos of it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...