Jump to content
SAU Community

Recommended Posts

hi guys,

i did a search & couldnt find what i was looking for - as of yesterday my knock has increased as i noticed this in 3rd gear when i got to 6500rpm @ 24psi, read 70+.

when i reduce the boost level to approx 20psi the knock drops to 40 (as per pfc) & even lower boost showed 25knock.

my tuner will check this out for me but in the meantime i would like to do a check over so i dont waste his time...paul (mr swiper) was suggested i blow out the loom connectors with an air compressor as water may have entered the connectors when i washed the engine bay last week & also to check that the spark plugs all look the same (maybe a plug has failed?)

is there anything else i should check OR has anyone else experienced high knock due to something rattling/loose in the engine bay? i dont want to feel like a d1ck with my tuner if something else is causing this bizarre reading...

thanks.

marko

Link to comment
https://www.sau.com.au/forums/topic/312402-knock-level-increasehmmm/
Share on other sites

  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Possible that you have picked up a bad batch of fuel. If nothing else has changed its weird that it will suddenly change.

I would have it looked at asap.

this is what i 1st thought - i ran the car basically dry then refilled at another bp servo (98 ultimate) & same thing.

It'll probably just be a cell that is slightly in need of attention.

Nothing major

yeah i had a squize at your pfc faq...you are probably right.

i have dropped the boost level anyway, better to be safe than sorry

It'll probably just be a cell that is slightly in need of attention.

Nothing major

+1

Yes indeedy, i had a knock reading of 120 randomly one day doing about 200kph, this was after consistantly never reading over 20 so probs like R31Nismoid said just a cell need a little love :P

Cheers,

Mitch.

or coils if the tune is good

If it were coils I would probably feel the loss in power in higher revs? Although this also crossed my mind

Would a faulty coil cause this symptom, I don't think so as the symptom would be hesitation

I will pull out the plugs tonight and if they look the same then off I go to my tuner

there wouldnt be any loss of power i would think it may just have a little unoticable missfire that would show up as knock. Happened to me.

But to be honest it sounds like your tune as your knock levels went down when you put loss power down.

tuned in summer? temps dropped up there recently? cold night maybe... other than that its probably as Ash suggested if you have already ruled out fuel

It was tuned on a 33deg day, the problem appeared on a 18deg day...could a drop in temp cause it?

Yes, most certainly.

As everyone has said, more than likely just a cell or two that need minor attention.

I think you need to buy a stress ball or something, a minor one-off knock is hardly anything to get excited about. :blush:

Take it back to the tuner, get it fixed. Should take less than 30mins. Drive it sensibly until then... easy as pie!

or coils if the tune is good

u might be right here - ji ust pulled out the plugs & no.4 plug is a lot blacker than the others...when i look at the coil pack for this plug it seems that the black lead tip on it is shorter than the others

paul - you are a legend mate, i think once again u are right - you freak!

i spoke jim @ crd & he explained that the coil pack was mis-firing with the pitted coil pack lead tip which is why the plug was black & this causes all sorts of things i.e. spark over which makes noise, even possible pinging.

i haven't test driven it yet but i'd say it is fixed :D im almost ready to put my head on the chopping block if its not rectified

i will report here once ive take it for a wrap on a long straight, 3rd gear under load

worse case i may need to buy a set of splitfire coilpacks

paul - you are a legend mate, i think once again u are right - you freak!

i spoke jim @ crd & he explained that the coil pack was mis-firing with the pitted coil pack lead tip which is why the plug was black & this causes all sorts of things i.e. spark over which makes noise, even possible pinging.

i haven't test driven it yet but i'd say it is fixed :D im almost ready to put my head on the chopping block if its not rectified

i will report here once ive take it for a wrap on a long straight, 3rd gear under load

worse case i may need to buy a set of splitfire coilpacks

:D

  • 3 weeks later...

hi guys,

last night i took my car for a drive with new my splitfire coil packs & it is still knocking high so ive left a msg for my tuner to look at my car. i was hoping the coil packs would have solved it but anyway...the joy of modded cars!

2nd gear showed 34 peak knock, 3rd gear showed 66 peak knock.

i then cruised below 3krpm in 4th gear @ 60kmh - when i reset the peak knock on my pfc hand controller it immediately shows above 20 peak knock & as high as 25 peak knock (i did this back2back test a no. of times & got the same result every time). HOW is this possible on such low revs??? i think my knock sensors are not reading correctly, either they may might need replacing as ive been told they can fail OR maybe 1 of them has become lose over time, i luv playing the guessing game (reminds me of an ex-girlfriend)

if the problem was just a cell that needs attention as suggested in my above posts, would i still have the same results considering the circumstances i.e. low revs, high knock?

20 on the knock is no issue. Just driving around mine i think sits around 10-20.

There is always going to be some noise picked up, the fuel is combusting after all.

You only really need to worry about knock when it gets over 30-35. Anything below that is largely irrelevant.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...