Jump to content
SAU Community

Recommended Posts

  • Replies 90
  • Created
  • Last Reply

Top Posters In This Topic

Dsturbd: Box is sold :D

pinoi_boi_r33: check PM

ApacheX: Nope, went with the engine. You probably know but the S1 and S2 AFM's are different, the S2 is a 3 wire/3 pin unit and the S1 is a 5 pin/4 wire unit.

I'm after the front drivers side mud guard that sits under the wheel arch.

It the piece that sits on under the wheel ooward the front bar.

I lost mine while driving down the freeway (thought I ran over a piece of re-tred).

I'm after the front drivers side mud guard that sits under the wheel arch.  

It the piece that sits on under the wheel ooward the front bar.

I lost mine while driving down the freeway (thought I ran over a piece of re-tred).

We do have this part however we are not sure if we need it at this stage. Will let you know in the next few days.

bozz, what are u willing to sell the aircon 'heater box with relays'? its the thing with the black thingy on top. If the price is right ill pick it up as soon as possible. I need it cos my aircon makes that taping noise. thanks

Driver side plastic bit, goes below dashboard, covers fuses, below steering wheel, above drivers knees $40

Bozz has this plastic thing got any turbo timer holes in it?

I think i've got what you're after. I dont have the leather surround but I do have the square metal bit that screws the rubber boot down to the chassis with 4 holes in it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...